Feed speed scheduling method for parts with rapidly varied geometric feature based on drive constraint of NC machine tool
暂无分享,去创建一个
Zhenyuan Jia | Jian-wei Ma | Ling Wang | Wei Liu | Kai Zhao | Kai Zhao | Zhenyuan Jia | Wei Liu | Jian-wei Ma | Lingli Wang
[1] Yuwen Sun,et al. A novel adaptive-feedrate interpolation method for NURBS tool path with drive constraints , 2014 .
[2] Xavier Beudaert,et al. 5-axis local corner rounding of linear tool path discontinuities , 2013 .
[3] Shih-Kai Wu,et al. Modeling and improvement of dynamic contour errors for five-axis machine tools under synchronous measuring paths , 2013 .
[4] Stefano Pisa,et al. A Twin Spiral Planar Antenna for UWB Medical Radars , 2013 .
[5] Miao Hu,et al. Bézier polygons for the linearization of dual NURBS curve in five-axis sculptured surface machining , 2012 .
[6] Xavier Beudaert,et al. 5-axis Tool Path Smoothing Based on Drive Constraints , 2011 .
[7] A. Sharaiha,et al. Size Reduced Multi-Band Printed Quadrifilar Helical Antenna , 2011, IEEE Transactions on Antennas and Propagation.
[8] Dong-Won Kim,et al. CBIMS: Case-based impeller machining strategy support system , 2009 .
[9] Ming-Yang Cheng,et al. Contouring accuracy improvement using cross-coupled control and position error compensator , 2008 .
[10] S. Khamas. Moment Method Analysis of an Archimedean Spiral Printed on a Layered Dielectric Sphere , 2008, IEEE Transactions on Antennas and Propagation.
[11] Yusuf Altintas,et al. Virtual Five-Axis Flank Milling of Jet Engine Impellers—Part II: Feed Rate Optimization of Five-Axis Flank Milling , 2008 .
[12] Yoshimi Takeuchi,et al. Tool Posture Determination for 5-Axis Control Machining by Area Division Method , 2006 .
[13] Aun-Neow Poo,et al. Tracking and contour error control in CNC servo systems , 2005 .
[14] Jih-Hua Chin,et al. Machining contour errors as ensembles of cutting, feeding and machine structure effects , 2003 .
[15] Syh-Shiuh Yeh,et al. Analysis and design of the integrated controller for precise motion systems , 1999, IEEE Trans. Control. Syst. Technol..
[16] Chih-Ching Lo,et al. Efficient cutter-path planning for five-axis surface machining with a flat-end cutter , 1999, Comput. Aided Des..
[17] Taiyong Wang,et al. Smooth feedrate planning for continuous short line tool path with contour error constraint , 2014 .
[18] I. Lazoglu,et al. Offline Force Control and Feedrate Scheduling for Complex Free Form Surfaces in 5-Axis Milling , 2012 .
[19] Gérard Poulachon,et al. Optimal strategy for finishing impeller blades using 5-axis machining , 2012 .
[20] Liu,et al. THIRD-ORDER LOCAL CONTACT AND APPLICATION IN 5-AXIS MACHINING OF SCULPTURED SURFACES , 2006 .