MODELLING OF THE 3D MACHINING GEOMETRIC DEFECTS ACCOUNTING FOR WORKPIECE VIBRATORY BEHAVIOUR

In this paper, we present a three-dimensional manufacturing tolerancement model. Several researchers have interested to modelling the machining geometric defects. The most researchers are limited to kinematic and static study. Only some works are evoked the dynamic effects, especially the influence of the chatter phenomenon on the roughness of the machined surface. In this context, the paper presents a contribution for modelling and quantification of the machining geometric defects where the machining dynamic effects are considered. A developed method is established based on Homogeneous Transformation Method in subject to determine the kinematical deviations caused by part locating and relocating. The dynamic displacements due to clamping and machining forces are defined using Finite Element Method. The numerical results are then compared to published experimental results. (Received in July 2010, accepted in February 2011. This paper was with the authors 2 months for 1 revision.)

[1]  S. Jack Hu,et al.  Modeling Machining Geometric Variation in a N-2-1 Fixturing Scheme , 2006 .

[2]  Pascal Ray,et al.  Stability-based spindle speed control during flexible workpiece high-speed milling , 2008 .

[3]  Riadh Chaari,et al.  A TENSORIAL MODELLING OF THE 3D INFLUENCE OF THE FIXTURE ERRORS ON THE ORIENTATIONAL GEOMETRIC SPECIFICATIONS , 2007 .

[4]  Yujing Feng.  A CAD based Computer-Aided Tolerancing Model for the Machining Process , 2004 .

[5]  Shreyes N. Melkote,et al.  Optimal Fixture Design Accounting for the Effect of Workpiece Dynamics , 2001 .

[6]  E. C. DeMeter,et al.  Restraint Analysis of Fixtures Which Rely on Surface Contact , 1994 .

[7]  Y.J.Gene Liao,et al.  Flexible multibody dynamics based fixture-workpiece analysis model for fixturing stability , 2000 .

[8]  Pascal Ray,et al.  Modelling Approach for a High Speed Machine Tool Spindle-Bearing System , 2005 .

[9]  Martin W. Trethewey,et al.  A model to predict minimum required clamp pre-loads in light of fixture–workpiece compliance , 2001 .

[10]  Necmettin Kaya,et al.  The Application of Chip Removal and Frictional Contact Analysis for Workpiece–Fixture Layout Verification , 2003 .

[11]  Warren R. DeVries,et al.  Optimization Methods Applied to Selecting Support Positions in Fixture Design , 1991 .

[12]  Ying Huang,et al.  Modeling Variation Propagation in Machining Systems With Different Configurations , 2002 .

[13]  G.S.A. Shawki,et al.  Effect of fixture rigidity and wear on dimensional accuracy , 1965 .

[14]  Paul H. Cohen,et al.  Dynamic modeling of the fixture-workpiece system , 1991 .

[15]  S. J. Hu,et al.  An Integrated Model of a Fixture-Workpiece System for Surface Quality Prediction , 2001 .