Investigation of shear lag failure in gusset-plate welded structural steel hollow section connections

Abstract Shear lag (SL) failure is a premature tensile failure that may occur in gusset-plate welded connections in structural steel hollow sections (SSHS). There have been a number of studies of SL failure in gusset-plate welded SSHS connections, but these are all limited to SSHS with a yield stress less than 500 MPa. This paper presents an investigation of SL failure for gusset-plate welded connections in very high strength (VHS) tubes with a yield stress of 1350 MPa, and SL design for gusset-plate welded connections in both VHS tubes and regular SSHS. Tensile tests on 16 specimens of gusset-plate welded connections in VHS tubes with various weld lengths were conducted. The experimental maximum connection strengths from the tensile tests were compared with predictions based on the existing SL design rules in the US, Canada and Australia. It was found that these design rules are not adequate. Therefore, modifications to these design rules were postulated and examined. Design rules are proposed for gusset-plate welded connections in all SSHS including VHS tubes. A capacity (resistance) factor of 0.70 is also proposed based on a reliability analysis using the first order second moment (FOSM) method.

[1]  Riadh Al-Mahaidi,et al.  Investigation of block shear tear-out failure in gusset-plate welded connections in structural steel hollow sections and very high strength tubes , 2007 .

[2]  Hui Jiao,et al.  Imperfection, residual stress and yield slenderness limit of very high strength (VHS) circular steel tubes , 2003 .

[3]  R. Al-Mahaidi,et al.  Rational design analysis of stub columns fabricated using very high strength circular steel tubes , 2005 .

[4]  Riadh Al-Mahaidi,et al.  Longitudinal Fillet Welds in Thin-Walled C450 RHS Members , 1999 .

[5]  J. J. Roger Cheng,et al.  Gusset Plate Connection to Round HSS Tension Members , 2003 .

[6]  Gregory J. Hancock,et al.  Butt Welds and Transverse Fillet Welds in Thin Cold-Formed RHS Members , 1995 .

[7]  Hui Jiao,et al.  Section slenderness limits of very high strength circular steel tubes in bending , 2004 .

[8]  E. Gaylord,et al.  Design of Steel Structures , 1972 .

[9]  Xiao Ling Zhao,et al.  Tension Capacity of Very High Strength (VHS) Circular Steel Tubes after Welding , 2004 .

[10]  Riadh Al-Mahaidi,et al.  Stub column tests of fabricated square and triangular sections utilizing very high strength steel tubes , 2004 .

[11]  Bruce Ellingwood,et al.  Development of a probability based load criterion for American National Standard A58 , 1980 .

[12]  Xiao Ling Zhao,et al.  Section capacity of very high strength (VHS) circular tubes under compression , 2000 .

[13]  T. V. Galambos.  Discussion of “Public Safety—Is It Compromised by New LRFD Design Standards?” by T. V. Galambos , 1995 .

[14]  R. M. Korol,et al.  Shear lag in slotted HSS tension members , 1996 .

[15]  Theodore V. Galambos,et al.  Load and Resistance Factor Design for Steel , 1978 .

[16]  Frank J. Heger.  PUBLIC SAFETY - IS IT COMPROMISED BY NEW LRFD DESIGN STANDARDS? , 1993 .

[17]  Jeffrey A Paker,et al.  Hollow structural section connections and trusses : a design guide , 1997 .