论文信息 - Optimization of an optopneumatic interface

Optimization of an optopneumatic interface

The optopneumatic interface consists of an optopneumatic detector (OPD) and four fluidic amplifiers connected in series. The optical signal is converted by photothermic effect into pneumatic signal in the OPD, connected with the control duct of the first fluidic amplifier. The OPD output pneumatic signal is amplified to obtain a signal whose amplitude is capable of controlling a common low/high pressure membrane valve.

Terenziano Raparelli | Gabriella Eula | Guido Belforte | Vladimir Viktorov | Matteo Martinelli

[1] Gabriella Eula,et al. Experimental optimization of an optopneumatic interface , 1999 .

[2] Terenziano Raparelli,et al. Bistable Fluidic Laminar Amplifiers for Optopneumatic Interfaces , 2003, J. Robotics Mechatronics.

[3] Terenziano Raparelli,et al. Theoretical and Experimental Investigations of an Opto-Pneumatic Detector , 2000 .

[4] B. Hockaday,et al. A Novel Opto-Fluidic Interface , 1984, 1984 American Control Conference.

[5] Gabriella Eula,et al. Analysis and construction of an optopneumatic interface , 1997 .

[6] Terenziano Raparelli,et al. Project and Experimentation of a Photoacoustic Cell , 1997, J. Robotics Mechatronics.

[7] Terenziano Raparelli,et al. Inlet effects in high-gain laminar fluidic amplifier , 1995 .

[8] Gabriella Eula. Studio di alcuni principi di commutazione di elementi fluidici , 1996 .

[9] Terenziano Raparelli,et al. Micro-interfacce optopneumatiche , 2001 .