Static Design and Finite Element Analysis of Innovative CFRP Transverse Leaf Spring

This paper describes the design and the numerical modelization of a novel transverse Carbon Fiber Reinforced Plastic (CFRP) leaf-spring prototype for a multilink suspension. The most significant innovation is in the functional integration where the leaf spring has been designed to work as spring, anti-roll bar, lower and longitudinal arms at the same time. In particular, the adopted work flow maintains a very close correlation between virtual simulations and experimental tests. Firstly, several tests have been conducted on the CFRP specimen to characterize the material property. Secondly, a virtual card fitting has been carried out in order to set up the leaf-spring Finite Element (FE) model using CRASURV formulation as material law and RADIOSS as solver. Finally, extensive tests have been done on the manufactured component for validation. The results obtained show a good agreement between virtual simulation and experimental tests. Moreover, this solution enabled the suspension to reduce about 75% of the total mass without losing performance.

[1]  유원재,et al.  Double tapered FRP beam for automotive suspension leaf spring = 자동차 현가장치에의 응용을 위한 이중 테이퍼를 갖는 섬유강화복합재 판스프링 , 1988 .

[2]  J. Keith Nisbett,et al.  Shigley's Mechanical Engineering Design , 1983 .

[3]  William F. Milliken,et al.  Race Car Vehicle Dynamics , 1994 .

[4]  Antonio Paolo Carlucci,et al.  New technologies demonstrated at Formula Electric and Hybrid Italy 2008 , 2009 .

[6]  D. Delsart,et al.  Evaluation of finite element modelling methodologies for the design of crashworthy composite commercial aircraft fuselage , 2004 .

[7]  Joo-teck Jeffrey Kueh,et al.  Finite element analysis on the static and fatigue characteristics of composite multi-leaf spring , 2012 .

[8]  Karen Wood.  Composite leaf springs: saving weight in production suspension systems , 2014 .

[9]  Rayner M. Mayer,et al.  Evolution of the eye-end design of a composite leaf spring for heavy axle loads , 2007 .

[10]  Massimiliana Carello,et al.  IDRApegasus: a carbon fiber monocoque vehicle prototype , 2014 .

[11]  P. Van den Bossche,et al.  The Cell versus the System: Standardization challenges for electricity storage devices , 2009 .

[12]  Massimiliana Carello,et al.  Optimization of IDRApegasus: Fuel Cell Hydrogen Vehicle , 2013 .

[13]  P. Beardmore,et al.  The potential for composites in structural automotive applications , 1986 .

[14]  Massimiliana Carello,et al.  Performance Optimization for the XAM Hybrid Electric Vehicle Prototype , 2012 .

[15]  H. Al-Qureshi,et al.  Automobile leaf springs from composite materials , 2001 .

[16]  Massimiliana Carello,et al.  Composite Suspension Arm Optimization for the City Vehicle XAM 2.0 , 2014 .

[17]  M. Shokrieh,et al.  Analysis and optimization of a composite leaf spring , 2003 .

[18]  Massimiliana Carello,et al.  Carbon fiber monocoque for a hydrogen prototype for low consumption challenge , 2010 .