The use of helical heat exchanger for heat recovery domestic water-cooled air-conditioners

Abstract An experimental study on the performance of a domestic water-cooled air-conditioner (WAC) using tube-in-tube helical heat exchanger for preheating of domestic hot water was carried out. The main aims are to identify the comprehensive energy performance (space cooling and hot water preheating) of the WAC and the optimum design of the helical heat exchanger taking into account the variation in tap water flow rate. A split-type WAC was set up for experimental study at different indoor and outdoor conditions. The cooling output, the amount of recovered heat, and the power consumption for different hot water flow rates were measured. The experimental results showed that the cooling coefficient of performance (COP) of the WAC improves with the inclusion of the heat recovery option by a minimum of 12.3%. This can be further improved to 20.6% by an increase in tap water flow rate. Same result was observed for the comprehensive COP of the WAC. The maximum achievable comprehensive COP was 4.92 when the tap water flow rate was set at 7.7 L/min. The overall heat transfer coefficient of the helical heat exchanger under various operating conditions were determined by Wilson plot. A mathematical model relating the over all heat transfer coefficient to the outer pipe diameter was established which provides a convenient way of optimising the design of the helical heat exchanger.

[1]  W. L. Lee,et al.  Simplifying energy performance assessment in the Hong Kong Building Environmental Assessment Method , 2001 .

[2]  G. Raghavan,et al.  Thermally dependent viscosity and non-Newtonian flow in a double-pipe helical heat exchanger , 2007 .

[3]  C. J. Hoogendoorn,et al.  Laminar convective heat transfer in helical coiled tubes , 1978 .

[4]  Liejin Guo,et al.  Transient convective heat transfer in a helical coiled tube with pulsatile fully developed turbulent flow , 1998 .

[5]  Yang Wang,et al.  An experimental study on a modified air conditioner with a domestic hot water supply (ACDHWS) , 2006 .

[6]  G.S.V. Raghavan,et al.  Comparison of heat transfer rates between a straight tube heat exchanger and a helically coiled heat exchanger , 2002 .

[7]  Timothy J. Rennie,et al.  NUMERICAL AND EXPERIMENTAL STUDIES OF A DOUBLE- PIPE HELICAL HEAT EXCHANGER , 2005 .

[8]  Jonathan Rose,et al.  Heat-transfer coefficients, Wilson plots and accuracy of thermal measurements , 2004 .

[9]  W. L. Lee,et al.  Applying water cooled air conditioners in residential buildings in Hong Kong , 2008 .

[10]  Tin-Tai Chow,et al.  Domestic air-conditioner and integrated water heater for subtropical climate , 2003 .

[11]  Paisarn Naphon,et al.  Thermal performance and pressure drop of the helical-coil heat exchangers with and without helically crimped fins , 2007 .

[12]  H. J Laue.  Regional report Europe: “heat pumps — status and trends” , 2002 .

[13]  Liejin Guo,et al.  Turbulent heat transfer in a horizontal helically coiled tube , 1999 .

[14]  José Fernández-Seara,et al.  A general review of the Wilson plot method and its modifications to determine convection coefficients in heat exchange devices , 2007 .

[15]  A. C. Ku,et al.  Thermal analysis of the performances of helical-type, roughened, double-pipe heat exchangers , 1987 .

[16]  Cheng-Xian Lin,et al.  Turbulent Heat Transfer to Near-Critical Water in a Heated Curved Pipe Under the Conditions of Mixed Convection , 1998, Heat Transfer: Volume 1 — Heat Transfer in Flowing Systems.

[17]  Cheng-Xian Lin,et al.  Condensation heat transfer and pressure drop characteristics of R-134a in an annular helical pipe , 2005 .