Dynamic Machine Operation Transitions

Wide angular velocity operation of an electrical machine is demonstrated by partitioning each of the stator coils of a three-phase configuration. An open-winding machine drive circuit is proposed with which dynamic transitions between machine operating modes can be executed. The principle of operation and the design choices of the required bidirectional series switch are explained and motivated. The behavior of the proposed system is analysed, and verified by simulations. Finally, the results of a configuration (gear) transition are compared to a state-of-the-art mechanical twin-clutch transmission, showing that both the angular jerk and transition time are much smaller with the proposed system.

[1]  Akihiro Odaka,et al.  ower conversion circuits currently in widespread use a DC-linked type converter that consists of rectifiers, electrolytic capacitors and DC reactors. Application technologies of reverse-blocking IGBT , 2008 .

[2]  T. Gerrits,et al.  Loss minimization of boost mode dual inverter drive system , 2013, 2013 15th European Conference on Power Electronics and Applications (EPE).

[3]  R.W. De Doncker,et al.  The auxiliary resonant commutated pole converter , 1990, Conference Record of the 1990 IEEE Industry Applications Society Annual Meeting.

[4]  Th. Hartkopf,et al.  A high speed induction machine with two-speed transmission as drive for electric vehicles , 2006, International Symposium on Power Electronics, Electrical Drives, Automation and Motion, 2006. SPEEDAM 2006..

[5]  Yimin Gao,et al.  Characterization of electric motor drives for traction applications , 2003, IECON'03. 29th Annual Conference of the IEEE Industrial Electronics Society (IEEE Cat. No.03CH37468).

[6]  Tore Undeland,et al.  Power Electronics: Converters, Applications and Design , 1989 .

[7]  D. A. Crolla,et al.  Dynamics and control of gearshifts on twin-clutch transmissions , 2005 .

[8]  Eckart Nipp,et al.  Permanent magnet motor drives with switched stator windings , 1999 .

[9]  T. Gerrits,et al.  Fault-Tolerant Operation of a Fully Electric Gearbox Equivalent , 2011, IEEE Transactions on Industry Applications.

[10]  Johannes J. H. Paulides,et al.  Flux-Switching Machine With DC Excitation , 2012, IEEE Transactions on Magnetics.

[11]  P. W. Rowland.  Low impact motor control with star-delta starting , 1998, 1998 IEEE Annual Textile, Fiber and Film Industry Technical Conference (Cat. No.98CH36246).

[12]  T. Gerrits,et al.  Electrical gearbox equivalent by means of dynamic machine operation , 2011, Proceedings of the 2011 14th European Conference on Power Electronics and Applications.

[13]  Johann W. Kolar,et al.  A novel three-phase utility interface minimizing line current harmonics of high-power telecommunications rectifier modules , 1997, IEEE Trans. Ind. Electron..