On the influence of RF absorbing material on the GNSS position

Abstract Reflections of the GNSS signal around the antenna induce an error in the measurement of the satellite–receiver distance and therefore should be avoided as much as possible. One solution often used to mitigate these reflections is to apply radio frequency (RF) absorbing material to the antenna, its support or its site. Such material could however alter the antenna phase delay and, in turn, alter the position as calculated from the GNSS observations. We explain under which conditions the RF material will or will not alter the antenna phase delay, and hence in which conditions a re-calibration of the antenna is necessary after the installation of absorbing material. Furthermore, rules of thumb are given to install the material in such a way that re-calibration can be avoided. Some basic theory and measurements of the influence of RF material are reviewed. An application to a real life absorber setup similar to one of the International GNSS Service reference stations is then discussed, and the position offset due to the absorbing material is demonstrated. The topics discussed can serve station managers to limit effects of absorbing material and take precautions to avoid a position bias.