Engine mount optimisation for vibration isolation in motorcycles

This paper presents a comprehensive model to capture the in-plane dynamics of a motorcycle system to evaluate the quality of its vibration isolation, and the design of an engine mount system. The model consists of two main structural components, the frame and the swing-arm, as well as the power-train assembly, engine mounts connecting the power-train to the frame, and the front-end assembly. The model accounts for frame and swing-arm flexibility using reduced order finite-element models. The power-train assembly is modelled as a rigid body connected to the frame through the engine mounts and to the swing-arm through a shaft assembly. The engine mounts are modelled as tri-axial spring-damper systems, and the front-end assembly is modelled as a lumped mass. The complete vehicle model is used to solve the engine mount optimisation problem, so as to minimise the total force transmitted to the frame while meeting packaging and other constraints. The mount system parameters – stiffness, position and orientation vectors – are used as design variables for the optimisation problem. The imposed loads include forces and moments due to engine imbalance as well as loads transmitted due to high amplitude, low frequency bump loads, through the tyre patch. Since packaging constraints play a significant role in a motorcycle layout, it is, therefore, important to determine the displacement envelope of the power-train under extreme loading conditions to ensure clearance with other components around the power-train. A motorcycle mount system should ideally be able to isolate the frame under steady-state loading conditions and at the same time limit the maximum excursion of the power-train under transient loading conditions.

[1]  Yoshihiko Sunayama,et al.  Prediction of Engine Mount Vibration using Multi Body Simulation with Finite Element Models , 2005 .

[2]  Hans B. Pacejka,et al.  Tire and Vehicle Dynamics , 1982 .

[3]  Shin Morishita,et al.  Optimal design of an engine mount using an enhanced genetic algorithm with simplex method , 2005 .

[4]  P. S. Heyns,et al.  Vibration isolation of a mounted engine through optimization , 1995 .

[5]  Tetsuya Seino,et al.  On the Theory of Orthogonal Engine Mount System and Its Application to Motorcycles , 1983 .

[6]  Takamasa Kamioka,et al.  Influence of the front fork on the movement of a motorcycle , 1997 .

[7]  V. Cossalter,et al.  A Motorcycle Multi-Body Model for Real Time Simulations Based on the Natural Coordinates Approach , 2002 .

[8]  Robin S. Sharp,et al.  The Stability and Control of Motorcycles , 1971 .

[9]  Jang Moo Lee,et al.  FLEXIBLE CHASSIS EFFECTS ON DYNAMIC RESPONSE OF ENGINE MOUNT SYSTEMS , 1995 .

[10]  Sudhir Kaul.  Modeling Techniques for Vibration Isolation in Motorcycles , 2011 .

[11]  Henry Wu,et al.  Optimization of aircraft engine suspension systems , 1991 .

[12]  Niccolò Baldanzini,et al.  Designing the Dynamic Behavior of an Engine Suspension System Through Genetic Algorithms , 2001 .

[13]  Roberto Lot,et al.  A General Method for the Evaluation of Vehicle Manoeuvrability with Special Emphasis on Motorcycles , 1999 .

[14]  Hashem Ashrafiuon.  Design Optimization of Aircraft Engine-Mount Systems , 1993 .

[15]  Robin S. Sharp,et al.  A Motorcycle Model for Stability and Control Analysis , 2001 .

[16]  Sudhir Kaul,et al.  Engine Mount Optimization for Vibration Isolation in Motorcycles , 2006 .

[17]  Ernst Friedrich Göbel.  Rubber springs design , 1974 .