High Accuracy and Miniature 2-D Wind Sensor for Boundary Layer Meteorological Observation †

Wind speed and direction are important parameters in meteorological observation. A solid wind sensor is needed with a small quadcopter for boundary layer meteorological observation. In this paper, the principle of a cylindrical two-dimensional wind sensor is reported and the data from wind tunnel experiments are analyzed. A model is proposed to describe the distribution of the pressure difference across a diameter of a cylinder, and the wind sensor is fabricated with MEMS (Micro-Electro-Mechanical System) differential pressure sensors. The wind sensor cylinder has a small size with a diameter of 30 mm and a height of 80 mm. In wind tunnel tests in the range of 1 to 40 m/s, the relative speed measuring errors and the direction measuring errors of the prototype are no more than ± (0.2 + 0.03 V) m/s (V is standard wind speed) and 5°, respectively. An inclination angle model is proposed to correct the influence of tilt angle on the quadcopter platform, the wind sensor can maintain the original wind speed and direction measurement accuracy within the 30° inclination range after compensation.

[1]  C. Liu,et al.  A directional cylindrical anemometer with four sets of differential pressure sensors. , 2016, The Review of scientific instruments.

[2]  David Z. Zhu,et al.  Drag force on a free surface-piercing yawed circular cylinder in steady flow , 2013 .

[3]  Jianmin Miao,et al.  High Sensitivity, Miniature, Full 2-D Anemometer Based on MEMS Hot-Film Sensors , 2013, IEEE Sensors Journal.

[4]  Zhen Fang,et al.  Drag force micro solid state silicon plate wind velocity sensor , 2009 .

[5]  F.,et al.  Wind Speed and Direction Detection by Means of Solid-state Anemometers Embedded on Small Quadcopters , 2017 .

[6]  Ellis Meng,et al.  Micromachined Thermal Flow Sensors - A Review , 2012, Micromachines.

[7]  Massimo Piotto,et al.  A Miniaturized 2D Solid State Anemometer Based on Thermal Flow Sensors , 2009 .

[8]  P. Bruschi,et al.  A Low-Power 2-D Wind Sensor Based on Integrated Flow Meters , 2009, IEEE Sensors Journal.

[9]  Ming Qin,et al.  Fabrication of a Micromachined Two-Dimensional Wind Sensor by Au–Au Wafer Bonding Technology , 2012, Journal of Microelectromechanical Systems.

[10]  Massimo Piotto,et al.  Fabrication and characterization of a directional anemometer based on a single chip MEMS flow sensor , 2011 .

[11]  朱燕青 黄庆安,et al.  Development of a self-packaged 2D MEMS thermal wind sensor for low power applications , 2015 .

[12]  Ming Qin,et al.  Development of a self-packaged 2D MEMS thermal wind sensor for low power applications , 2015 .

[13]  S. Hoerner.  Fluid Dynamic Drag: Practical Information on Aerodynamic Drag and Hydrodynamic Resistance , 1965 .