Induction motor equivalent circuit modeling is addressed. Data for induction motors are often not available in the form required by the equivalent circuit. An efficient method is therefore needed to find the resistances and reactances in the equivalent circuit from the data normally available. The method should be flexible enough to be applied both when complete current, torque, and power factor vs. slip curves are available and when only a few points on these curves are known. Using the method described, the induction machine equivalent circuit impedances can be found from the normally available information. The method involves some calculations which can be computerized, but also requires engineering judgment during the solution process. The computer program structure facilitates the necessary computer-engineer interaction. The method is iterative, and an interactive computer program relieves the engineer of much of the computational burden. Also discussed is the appropriate level of induction motor modeling for various types of dynamic studies. >
[1]
G. J. Rogers,et al.
Induction Machine Modelling for Electromagnetic Transient Program
,
1987,
IEEE Power Engineering Review.
[2]
B. Szabados,et al.
Measurement of the torque-speed characteristics of induction motors using an improved new digital approach
,
1990
.
[3]
T. A. Higgins,et al.
A comparison of induction motor models for bus transfer studies
,
1990
.
[4]
Ronald G. Harley,et al.
The General Theory of Alternating Current Machines
,
1975
.
[5]
Thomas A. Lipo,et al.
Measurement and computation of starting torque pulsations of salient pole synchronous motors
,
1990
.
[6]
J. S. Edmonds,et al.
Derivation of Induction Motor Models from Standstill Frequency Response Tests
,
1989,
IEEE Power Engineering Review.