Temperature Effects on the Wind Direction Measurement of 2D Solid Thermal Wind Sensors

For a two-dimensional solid silicon thermal wind sensor with symmetrical structure, the wind speed and direction information can be derived from the output voltages in two orthogonal directions, i.e., the north-south and east-west. However, the output voltages in these two directions will vary linearly with the ambient temperature. Therefore, in this paper, a temperature model to study the temperature effect on the wind direction measurement has been developed. A theoretical analysis has been presented first, and then Finite Element Method (FEM) simulations have been performed. It is found that due to symmetrical structure of the thermal wind sensor, the temperature effects on the output signals in the north-south and east-west directions are highly similar. As a result, the wind direction measurement of the thermal wind sensor is approximately independent of the ambient temperature. The experimental results fit the theoretical analysis and simulation results very well.

[1]  F. Kohl,et al.  MEMS Thermal Flow Sensor With Smart Electronic Interface Circuit , 2012, IEEE Sensors Journal.

[2]  Remco J. Wiegerink,et al.  Thermal Flow-Sensor Drift Reduction by Thermopile Voltage Cancellation via Power Feedback Control , 2014, Journal of Microelectromechanical Systems.

[3]  Androula G. Nassiopoulou,et al.  Novel Air Flow Meter for an Automobile Engine Using a Si Sensor with Porous Si Thermal Isolation , 2012, Sensors.

[4]  Carles Cané,et al.  Multi-range silicon micromachined flow sensor , 2004 .

[5]  P. Bruschi,et al.  A Low-Power 2-D Wind Sensor Based on Integrated Flow Meters , 2009, IEEE Sensors Journal.

[6]  Gerald Urban,et al.  Wide range semiconductor flow sensors , 2000 .

[7]  Walter Lang,et al.  Thermal flow sensor for liquids and gases based on combinations of two principles , 1999 .

[8]  Sekwang Park,et al.  The temperature compensation of a thermal flow sensor by changing the slope and the ratio of resistances , 2004 .

[9]  Ming Qin,et al.  Flip-Chip Packaging for a Two-Dimensional Thermal Flow Sensor Using a Copper Pillar Bump Technology , 2007, IEEE Sensors Journal.

[10]  Kofi A. A. Makinwa,et al.  A smart wind sensor using thermal sigma-delta modulation techniques , 2002 .

[11]  Walter Lang,et al.  A Temperature Compensation Circuit for Thermal Flow Sensors Operated in Constant-Temperature-Difference Mode , 2010, IEEE Transactions on Instrumentation and Measurement.

[12]  A. Nassiopoulou,et al.  A smart flow measurement system for flow evaluation with multiple signals in different operation modes , 2007 .

[13]  P Bruschi,et al.  An Offset Compensation Method With Low Residual Drift for Integrated Thermal Flow Sensors , 2011, IEEE Sensors Journal.

[14]  P. Tsilingiris.  Thermophysical and transport properties of humid air at temperature range between 0 and 100 °C , 2008 .

[15]  Ming Qin,et al.  Effects of Ambient Humidity on a Micromachined Silicon Thermal Wind Sensor , 2014, Journal of Microelectromechanical Systems.

[16]  B. W. Oudheusden,et al.  Silicon thermal flow sensor with a two-dimensional direction sensitivity , 1990 .

[17]  Yvonne Neudorf.  Electronic Materials And Processes Handbook , 2016 .

[18]  Denis Flandre,et al.  Out-of-plane MEMS-based mechanical airflow sensor co-integrated in SOI CMOS technology , 2014 .

[19]  A. W. van Herwaarden,et al.  High-sensivity 2-D flow sensor with an etched thermal isolation structure , 1990 .

[20]  Sekwang Park,et al.  A circular-type thermal flow direction sensor free from temperature compensation , 2003 .

[21]  Ming Qin,et al.  2-D Micromachined Thermal Wind Sensors—A Review , 2014, IEEE Internet of Things Journal.

[22]  Walter Lang,et al.  Membrane-based thermal flow sensors on flexible substrates , 2013 .

[23]  Rong Zhu,et al.  Temperature compensation for thermal anemometers using temperature sensors independent of flow sensors , 2011 .

[24]  Ming Qin,et al.  Modeling of Temperature Effects on Micromachined Silicon Thermal Wind Sensors , 2015, Journal of Microelectromechanical Systems.