Plasticization of ultra-thin polysulfone membranes by carbon dioxide

Abstract Plasticization of gas separation membranes by carbon dioxide permanently alters their performance and increases the possibility of membrane failure. This is amplified in ultra-thin composite membranes, where the active polymeric layer is less than 2 μm. Here, the plasticization influence of CO 2 is measured on ultra-thin polysulfone composite membranes for a range of active layer thicknesses, at four temperatures. The resulting permeability–pressure isotherms demonstrate plasticization occurs for all thicknesses at pressures lower than has been reported for dense membranes. These isotherms were quantitatively fitted with an expanded dual-sorption model that takes into account plasticization of the membrane. The plasticization potential of CO 2 for polysulfone was found to increase with reduced active layer thickness. Similarly, the plasticization potential of CO 2 was found to decrease with temperature. These results are consistent with similar research that shows that thin films behave differently to dense membranes.

[1]  S. Bae,et al.  Sorption and permeation behavior for a gas in glassy polymer membrane near the glass transition temperature , 1996 .

[2]  D. R. Paul,et al.  Gas transport properties of adamantane-based polysulfones , 1995 .

[3]  Matthias Wessling,et al.  Accelerated plasticization of thin-film composite membranes used in gas separation , 2001 .

[4]  Y. Yampolskii.  Polymeric Gas Separation Membranes , 1993 .

[5]  S. Goh,et al.  The accelerated CO2 plasticization of ultra-thin polyimide films and the effect of surface chemical cross-linking on plasticization and physical aging , 2003 .

[6]  Joseph L. Keddie,et al.  Size-Dependent Depression of the Glass Transition Temperature in Polymer Films , 1994 .

[7]  Matthias Wessling,et al.  CO2-induced plasticization phenomena in glassy polymers , 1999 .

[8]  Richard W. Baker,et al.  Natural Gas Processing with Membranes: An Overview , 2008 .

[9]  P. Pfromm,et al.  Accelerated physical ageing of thin glassy polymer films: evidence from gas transport measurements , 1995 .

[10]  Clem E. Powell,et al.  Polymeric CO2/N2 gas separation membranes for the capture of carbon dioxide from power plant flue gases , 2006 .

[11]  Jin-sheng Wang,et al.  A method of validation and parameter evaluation for dual-mode sorption model , 1999 .

[12]  James A. Forrest,et al.  Interface and chain confinement effects on the glass transition temperature of thin polymer films , 1997 .

[13]  W. Koros,et al.  Effect of structural symmetry on gas transport properties of polysulfones , 1992 .

[14]  W. Koros,et al.  Effect of partially immobilizing sorption on permeability and the diffusion time lag , 1976 .

[15]  D. R. Paul,et al.  Experimental methods for tracking physical aging of thin glassy polymer films by gas permeation , 2004 .

[16]  W. Koros,et al.  Gas transport properties of biphenol polysulfones , 1992 .

[17]  K. Nagai,et al.  Operating temperature effects on the plasticization of polyimide gas separation membranes , 2007 .

[18]  S. A. Stern,et al.  Concentration-dependent transport of gases and vapors in glassy polymers , 1980 .

[19]  S. A. Stern,et al.  The effect of plasticization on the transport of gases in and through glassy polymers , 1989 .

[20]  Richard A. L. Jones.  The dynamics of thin polymer films , 1999 .

[21]  Dianne E. Wiley,et al.  Reducing the Cost of CO2 Capture from Flue Gases Using Membrane Technology , 2008 .

[22]  A. Yee,et al.  Interface and surface effects on the glass transition in thin polystyrene films , 1997 .