The Effect of Impeller Cutback on the Fluid-Dynamic Pulsations and Load at the Blade-Passing Frequency in a Centrifugal Pump

A study is presented on the fluid-dynamic pulsations and the corresponding dynamic forces generated in a centrifugal pump with single suction and vaneless volute due to blade-volute interaction. Four impellers with different outlet diameters, obtained from progressive cutbacks (trimmings) of the greatest one, were successively considered in the test pump, so that the radial gap between the impeller and the volute ranged from 8.8% to 23.2% of the impeller radius. The study was based on the numerical computation of the unsteady flow through the machine for a number of flow rates by means of the FLUENT code, solving the 3D unsteady Reynolds-averaged Navier-Stokes equations. Additionally, an experimental series of tests was conducted for the pump with one of the impellers, in order to obtain pressure fluctuation data along the volute front wall that allowed contrasting the numerical predictions. The data collected from the numerical computations were used to estimate the dynamic radial forces and torque at the blade-passing frequency, as a function of flow rate and blade-tongue radial gap. As expected, for a given impeller diameter, the dynamic load increases for off-design conditions, especially for the low range of flow rates, whereas the progressive reduction of the impeller-tongue gap brings about corresponding increments in dynamic load. In particular, varying the blade-tongue gap within the limits of this study resulted in multiplying the maximum magnitude of the blade-passing frequency radial force by a factor of about 4 for low flow rates (i.e., below the nominal flow rate) and 3 for high flow rates.

[1]  Jorge Parrondo,et al.  Steady and unsteady radial forces for a centrifugal pump with impeller to tongue gap variation , 2006 .

[2]  Thomas Staubli,et al.  The Unsteady Pressure Field in a High Specific Speed Centrifugal Pump Impeller— Part I: Influence of the Volute , 1999 .

[3]  U. Bolleter,et al.  Pressure pulsations in centrifugal pumps , 1992 .

[4]  Ronald D. Flack,et al.  Two-Dimensional Flow Analysis of a Laboratory Centrifugal Pump , 1992 .

[5]  Joaquin Fernandez-Francos,et al.  The Effect of the Operating Point on the Pressure Fluctuations at the Blade Passage Frequency in the Volute of a Centrifugal Pump , 2002 .

[6]  Christopher E. Brennen,et al.  Hydrodynamics of Pumps , 1995 .

[7]  Hiroshi Tsukamoto,et al.  Unsteady Hydrodynamic Forces due to Rotor-Stator Interaction on a Diffuser Pump With Identical Number of Vanes on the Impeller and Diffuser , 2005 .

[8]  José M. González,et al.  Numerical Simulation of the Dynamic Effects Due to Impeller-Volute Interaction in a Centrifugal Pump , 2002 .

[9]  Kitano Majidi.  Numerical Study of Unsteady Flow in a Centrifugal Pump , 2005 .

[10]  N. P. Kruyt,et al.  Hydraulic Performance of a Mixed-Flow Pump: Unsteady Inviscid Computations and Loss Models , 2001 .

[11]  B. Neumann,et al.  The Interaction Between Geometry and Performance of a Centrifugal Pump , 2005 .

[12]  R. A. Van den Braembussche,et al.  Three-Dimensional Unsteady Flow and Forces in Centrifugal Impellers With Circumferential Distortion of the Outlet Static Pressure , 1997 .

[13]  D. S. Weaver,et al.  Sound Generation by a Centrifugal Pump at Blade Passing Frequency , 1998 .

[14]  José M. González,et al.  Unsteady Flow Structure and Global Variables in a Centrifugal Pump , 2006 .

[15]  Joseph Katz,et al.  Relationship Between Unsteady Flow, Pressure Fluctuations, and Noise in a Centrifugal Pump—Part B: Effects of Blade-Tongue Interactions , 1995 .

[16]  Christian Brix Jacobsen,et al.  Flow in a Centrifugal Pump Impeller at Design and Off-Design Conditions—Part II: Large Eddy Simulations , 2003 .

[17]  Uriel Goldberg,et al.  A Three-Layer Model for Separated Turbulent Flows , 1992 .

[18]  T. Maeda,et al.  Unsteady pressure distributions and forces on the impeller blades of a centrifugal pump. , 1988 .

[19]  Joseph Katz,et al.  Effect of Modification to Tongue and Impeller Geometry on Unsteady Flow, Pressure Fluctuations, and Noise in a Centrifugal Pump , 1997 .

[20]  David Japikse,et al.  Centrifugal pump design and performance , 1997 .

[21]  Hiroshi Tsukamoto,et al.  Fundamental Analysis on Rotor-Stator Interaction in a Diffuser Pump by Vortex Method , 2001 .

[22]  Hiroshi Tsukamoto,et al.  Numerical Study of Pressure Fluctuations Caused by Impeller-Diffuser Interaction in a Diffuser Pump Stage , 2001 .