Use of MMG Signals for the Control of Powered Orthotic Devices: Development of a Rectus Femoris Measurement Protocol

ABSTRACT A test protocol is defined for the purpose of measuring rectus femoris mechanomyographic (MMG) signals. The protocol is specified in terms of the following: measurement equipment, signal processing requirements, human postural requirements, test rig, sensor placement, sensor dermal fixation, and test procedure. Preliminary tests of the statistical nature of rectus femoris MMG signals were performed, and Gaussianity was evaluated by means of a two-sided Kolmogorov-Smirnov test. For all 100 MMG data sets obtained from the testing of two volunteers, the null hypothesis of Gaussianity was rejected at the 1%, 5%, and 10% significance levels. Most skewness values were found to be greater than 0.0, while all kurtosis values were found to be greater than 3.0. A statistical convergence analysis also performed on the same 100 MMG data sets suggested that 25 MMG acquisitions should prove sufficient to statistically characterize rectus femoris MMG. This conclusion is supported by the qualitative characteristics of the mean rectus femoris MMG power spectral densities obtained using 25 averages.

[1]  T J Housh,et al.  Mechanomyographic responses to maximal eccentric isokinetic muscle actions. , 1997, Journal of applied physiology.

[2]  Roger Pinnington,et al.  Vibration testing, theory and practice , 1998 .

[3]  T. R. Thompson,et al.  Recording sound from human skeletal muscle: Technical and physiological aspects , 1989, Muscle & nerve.

[4]  Clare E. Elwell,et al.  A Practical Users Guide to Near Infrared Spectroscopy , 1995 .

[5]  R. Merletti,et al.  Effect of accelerometer location on mechanomyogram variables during voluntary, constant-force contractions in three human muscles , 2006, Medical and Biological Engineering and Computing.

[6]  A. Davelli,et al.  Mini Joystick for Upper Limbs Prostheses , 2002 .

[7]  D T Barry,et al.  Acoustic myography as a control signal for an externally powered prosthesis. , 1986, Archives of physical medicine and rehabilitation.

[8]  G. R. Muller,et al.  Brain oscillations control hand orthosis in a tetraplegic , 2000, Neuroscience Letters.

[9]  P. Slycke,et al.  Ambulatory systems for enhanced human motor control , 2001 .

[10]  Tim Miller,et al.  Orthotics: Clinical Practice and Rehabilitation Technology , 1996 .

[11]  Tom Chau,et al.  A self-contained, mechanomyography-driven externally powered prosthesis. , 2005, Archives of physical medicine and rehabilitation.

[12]  M. Griffin,et al.  A data correction method for surface measurement of vibration on the human body. , 1995, Journal of biomechanics.

[13]  B. Harrison Las Vegas, Nevada , 2002 .

[14]  Jon Schuller Data Acquisition Board , 1996 .

[15]  Terenziano Raparelli,et al.  DEVELOPMENT OF A PNEUMATIC KNEE ORTHOSIS , 2002 .

[16]  Anthony M J Bull,et al.  Arthroscopically insertable force probes in the rotator cuff in vivo. , 2003, Arthroscopy : the journal of arthroscopic & related surgery : official publication of the Arthroscopy Association of North America and the International Arthroscopy Association.

[17]  Terenziano Raparelli,et al.  Powered lower limb orthosis for assisting standing up and sitting down movements , 2004 .

[18]  C. Orizio,et al.  Surface mechanomyogram reflects muscle fibres twitches summation. , 1996, Journal of biomechanics.

[19]  T J Housh,et al.  Mean power frequency and amplitude of the mechanomyographic and electromyographic signals during incremental cycle ergometry. , 2001, Journal of electromyography and kinesiology : official journal of the International Society of Electrophysiological Kinesiology.

[20]  M. Stokes,et al.  Acoustic myographic activity increases linearly up to maximal voluntary isometric force in the human quadriceps muscle , 1991, Journal of the Neurological Sciences.

[21]  Jacob Rosen,et al.  A myosignal-based powered exoskeleton system , 2001, IEEE Trans. Syst. Man Cybern. Part A.

[22]  K. Akataki,et al.  Technical aspects of mechnomyography recording with piezoelectric contact sensor , 1998, Medical and Biological Engineering and Computing.

[23]  Terry J. Housh,et al.  MECHANOMYOGRAPHIC AND ELECTROMYOGRAPHIC RESPONSES TO ISOKINETIC MUSCLE ACTIONS , 2001 .

[24]  D Howard,et al.  Dimensional change in muscle as a control signal for powered upper limb prostheses: a pilot study. , 1999, Medical engineering & physics.

[25]  P H Peckham,et al.  EEG-based control of a hand grasp neuroprosthesis. , 1999, Neuroreport.

[26]  J. Giacomin,et al.  01A1084 Application of Mildly Nonstationary Mission Synthesis (MNMS) to Automotive Road Data , 2001 .

[27]  Daniel P. Ferris,et al.  An ankle-foot orthosis powered by artificial pneumatic muscles. , 2005, Journal of applied biomechanics.

[28]  C. Orizio Muscle sound: bases for the introduction of a mechanomyographic signal in muscle studies. , 1993, Critical reviews in biomedical engineering.

[29]  Roger Sauter,et al.  Introduction to Probability and Statistics for Engineers and Scientists , 2005, Technometrics.

[30]  Pol E Huysmans,et al.  Paper #14 The reliability of MR-arthrography in patients with anterior shoulder instability , 2003 .

[31]  Toshio Moritani,et al.  Characteristics of surface mechanomyogram are dependent on development of fusion of motor units in humans. , 2002, Journal of applied physiology.

[32]  J. Basmajian,et al.  Orthotics : clinical pratice and rehabilitation technology , 1995 .

[33]  W. Craelius,et al.  CONTROL OF A MULTI-FINGER PROSTHETIC HAND , 1999 .

[34]  Yukio Kobayashi,et al.  Tissue oxygenation monitor using NIR spatially resolved spectroscopy , 1999, Photonics West - Biomedical Optics.

[35]  Tom Chau,et al.  Coupled microphone-accelerometer sensor pair for dynamic noise reduction in MMG signal recording , 2003 .

[36]  A. P,et al.  Mechanical Vibrations , 1948, Nature.