Simulation of HTS Josephson Mixers

The Commonwealth Scientific and Industrial Research Organization has developed superconducting microwave monolithic integrated circuit (MMIC) mixers using step-edge Josephson junctions and on-chip filters, made from YBaCuO on MgO substrates. Integration into an MMIC results in a compact and efficiently coupled structure. These have been shown to have outstanding conversion efficiency, dynamic range, and linearity. We report here a range of simulations of this type of mixer. We have mainly used Josephson simulators and analyze the data in both the time and frequency domains. More recently, we have also used microwave simulators incorporating a novel Verilog-A Josephson junction model that we have developed. We have looked at the interactions of junction bias current, local oscillator power, and radio-frequency input power with conversion efficiency, dynamic range, and linearity. Good agreement is found overall with measurements.

[1]  Jia Du,et al.  30 GHz HTS Receiver Front-End Based on Monolithic Josephson Mixer , 2015, IEEE Transactions on Applied Superconductivity.

[2]  Y. Wang,et al.  Toward terahertz heterodyne detection with superconducting Josephson junctions , 2012 .

[3]  Jia Du,et al.  A high-temperature superconducting monolithic microwave integrated Josephson down-converter with high conversion efficiency , 2013 .

[4]  Yuan Taur.  Josephson-junction mixer analysis using frequency-conversion and noise-correlation matrices , 1980, IEEE Transactions on Electron Devices.

[5]  Jia Du,et al.  A 7–8.5 GHz High Performance MMIC HTS Josephson Mixer , 2013, IEEE Microwave and Wireless Components Letters.

[6]  Yingjie Jay Guo,et al.  On-chip integration of HTS bandpass and lowpass filters with Josephson mixer , 2012 .

[7]  H. Uhlmann,et al.  Accurate calculation of capacitances of grain boundary Josephson junctions in high critical temperature superconductors , 1995 .

[8]  Katsumi Suzuki,et al.  Y-Ba-Cu-O mixer antenna array at 23 GHz , 1994, 1994 IEEE MTT-S International Microwave Symposium Digest (Cat. No.94CH3389-4).

[9]  Cathy P. Foley,et al.  YBCO step-edge junctions with high IcRn , 2010 .

[10]  Jia Du,et al.  A self-pumped high-temperature superconducting Josephson mixer: Modelling and measurement , 2012 .

[11]  Paul L. Richards,et al.  Josephson Junctions as Heterodyne Detectors , 1974, 1974 International Conference on Submillimeter Waves and Their Applications.

[12]  Jia Du,et al.  A compact high temperature superconducting bandpass filter for integration with a Josephson mixer , 2013 .

[13]  Jia Du,et al.  Design and integration of HTS filters with a Josephson device , 2012 .

[14]  C. M. Pegrum,et al.  Optimised conversion efficiency of a HTS MMIC Josephson down-converter , 2014 .

[15]  N. Yazawa,et al.  Noise figure of HTS JJ MMIC downconverter at 12 GHz , 1993, 1993 IEEE MTT-S International Microwave Symposium Digest.

[16]  E. S. Fang,et al.  A Josephson integrated circuit simulator (JSIM) for superconductive electronics application , 1989 .

[17]  G. Faini,et al.  High-Tc superconducting Josephson mixers for terahertz heterodyne detection , 2014 .

[18]  S. Fujino,et al.  X-Band Mixing Performance of Y1Ba2Cu3O7-x Step-Edge Junction , 1994 .

[19]  C. Foley,et al.  Fabrication and characterisation of YBCO single grain boundary step edge junctions , 1999, IEEE Transactions on Applied Superconductivity.

[20]  K. Yamaguchi,et al.  IF output characteristics of Josephson mixer , 1997 .

[21]  J. Satchell,et al.  Stochastic simulation of SFQ logic , 1997, IEEE Transactions on Applied Superconductivity.

[22]  Hanspeter Schmid,et al.  How to use the FFT and Matlab's pwelch function for signal and noise simulations and measurements , 2012 .