L2 Two-Phase Gas-Liquid Flow

[1]  L. Friedel,et al.  Two-phase gas/liquid flow pressure loss in bends , 1999 .

[2]  Ralf Diener,et al.  Sizing of throttling device for gas/liquid two‐phase flow part 2: Control valves, orifices, and nozzles , 2005 .

[3]  V. Kadambi.  Void fraction and pressure drop in two phase stratified flow , 1981 .

[4]  S. Ergun.  Fluid flow through packed columns , 1952 .

[5]  James R. Fair,et al.  Distillation: Principles and Practices , 1998 .

[6]  G. Wallis.  One Dimensional Two-Phase Flow , 1969 .

[7]  A. Mersmann.  Zur Berechnung des Flutpunktes in Füllkörperschüttungen , 1965 .

[8]  J. Leung,et al.  A Generalized Correlation for Two-Phase Nonflashing Homogeneous Choked Flow , 1990 .

[9]  Geoffrey F. Hewitt,et al.  Flooding in vertical two-phase flow , 1985 .

[10]  G. Hewitt,et al.  Studies of Two-Phase Flow Patterns by Simultaneous X-Ray and Flash Photography , 1969 .

[11]  H. C. Simpson,et al.  Two phase flow through gate valves and orifice plates , 1981 .

[12]  Iso Tc.  Safety devices for protection against excessive pressure — Sizing of safety valves and connected inlet and outlet lines for gas/liquid two- phase flow , 2007 .

[13]  Richard T. Lahey,et al.  The measurement of phase separation in wyes and tees , 1981 .

[14]  J. Henry,et al.  DIVIDING ANNULAR FLOW IN A HORIZONTAL TEE , 1981 .

[15]  S. D. Morris.  Compressible Gas-Liquid Flow through Pipeline Restrictions , 1991 .

[16]  Daniel D. Joseph,et al.  Power law and composite power law friction factor correlations for laminar and turbulent gas–liquid flow in horizontal pipelines , 2003 .

[17]  Stuart W. Churchill,et al.  A general expression for the correlation of rates of transfer and other phenomena , 1972 .

[18]  J. C. Leung,et al.  A generalized correlation for one‐component homogeneous equilibrium flashing choked flow , 1986 .

[19]  Joseph C. Leung.  Similarity between flashing and nonflashing two-phase flows , 1990 .

[20]  Shinichi Morooka,et al.  Experimental study on void fraction in a simulated BWR fuel assembly (evaluation of cross-sectional averaged void fraction) , 1989 .

[21]  Geoffrey F. Hewitt,et al.  Flooding and churn flow in vertical pipes , 1991 .

[22]  A. Inoue,et al.  A co-current stratified air-mercury flow with wavy interface , 1980 .

[23]  James P. Brill,et al.  A Study of Two-Phase Flow in Inclined Pipes , 1973 .

[24]  A. Inoue,et al.  The prediction of stratified two-phase flow with a two-equation model of turbulence , 1981 .

[25]  J. Thome,et al.  Comparison of experimental pressure drop data for two phase flows to prediction methods using a general model , 2007 .

[26]  Franz Mayinger,et al.  Strömung und Wärmeübergang in Gas-Flüssigkeits-Gemischen , 1982 .

[27]  K. S. Rezkallah,et al.  Void fraction measurements in gas-liquid flows under 1 - g and μ - g conditions using capacitance sensors , 1997 .

[28]  Haruhiko Ohta,et al.  Review of Reduced Gravity Boiling Heat Transfer : Japanese Research , 2003 .

[29]  J. Thome,et al.  Flow pattern based two-phase frictional pressure drop model for horizontal tubes. Part I: Diabatic and adiabatic experimental study , 2007 .

[30]  H. S. Oates,et al.  Two-phase steam-water flow through Y-junctions , 1979 .

[31]  S. D. Morris.  Discharge coefficients for choked gas—liquid flow through nozzles and orifices and applications to safety devices , 1990 .

[32]  A. Dukler,et al.  A model for predicting flow regime transitions in horizontal and near horizontal gas‐liquid flow , 1976 .

[33]  J. Schmidt.  Sizing of nozzles, venturis, orifices, control and safety valves for initially sub-cooled gas/liquid two-phase flow – The HNE-DS method , 2007 .

[34]  J. Thom,et al.  Prediction of pressure drop during forced circulation boiling of water , 1964 .

[35]  Joseph C. Leung,et al.  Easily size relief devices and piping for two-phase flow , 1996 .

[36]  H. Brauer.  Druckverlust in Füllkörpersäulen bei Einphasenströmung , 1957 .

[37]  S. Y. Ahmad.  Axial Distribution of Bulk Temperature and Void Fraction in a Heated Channel With Inlet Subcooling , 1970 .

[38]  Y. Shimizu,et al.  Hydraulic Losses and Flow Patterns of a Swirling Flow in U-Bends , 1980 .

[39]  L. Friedel.  Improved Friction Pressure Drop Correlation for Horizontal and Vertical Two-Phase Pipe Flow , 1979 .

[40]  M. Jensen,et al.  Two‐phase pressure drop in vertical crossflow across a horizontal tube bundle , 1988 .

[41]  H. S. Seifert,et al.  Compressibility Effects in Two‐Phase Flow , 1949 .

[42]  Robert E. Henry,et al.  The Two-Phase Critical Flow of One-Component Mixtures in Nozzles, Orifices, and Short Tubes , 1971 .

[43]  J. Thome,et al.  Flow pattern based two-phase frictional pressure drop model for horizontal tubes, Part II: New phenomenological model , 2007 .

[44]  R. Billet,et al.  Druckverlust in berieselten Schüttungen , 1989 .

[45]  Transiente Zweiphasen-Strömung , 1986 .

[46]  D. Chisholm.  Two-Phase Flow in Pipelines and Heat Exchangers , 1983 .

[47]  J. Maćkowiak,et al.  Application of modern packings in thermal separation processes , 1988 .

[48]  E. S. Starkman,et al.  Expansion of a Very Low Quality Two-Phase Fluid Through a Convergent-Divergent Nozzle , 1964 .

[49]  D A McNeil.  Two-phase flow in orifice plates and valves , 2000 .