The chemistry of additives in damascene copper plating

Copper plating baths used for forming integrated circuit interconnects typically contain three or four component additive mixtures which facilitate the superfilling of via holes and trench lines during damascene plating. Extensive study over the last two decades has provided researchers with an understanding of the underlying mechanisms. The role of cuprous intermediates in the copper deposition reaction has long been acknowledged, but it is not yet fully understood. In this paper we describe the results of an electrochemical study of the interaction of the organic additives used with copper and copper ions in solution. It is shown that cuprous intermediates near the copper surface affect the overpotential and the kinetics of plating. The additives regulate the presence of cuprous species on the surface; levelers and suppressors inhibit Cu+ formation, whereas accelerating additives enhance Cu+ formation. Acceleration by the bis(sodiumsulfopropyl) disulfide (SPS) additive results from accumulation of cuprous complexes near the surface. Adsorbed cuprous thiolate [Cu(I)(S(CH2)3 SO3H)ad] is formed through interaction of Cu+ ions and SPS rather than Cu2+ and mercaptopropane sulfonic acid (MPS).

[1]  Derek Pletcher,et al.  The chemistry of the additives in an acid copper electroplating bath , 1992 .

[2]  Allen J. Bard,et al.  Electrochemical Methods: Fundamentals and Applications , 1980 .

[3]  J. Shieh,et al.  Electroplating copper in sub-100 nm gaps by additives with low consumption and diffusion ability , 2002 .

[4]  S. Bruckenstein,et al.  A ring-disk electrode study of the electrochemical reduction of copper(II) in 0.2M sulfuric acid on platinum , 1968 .

[5]  T. Moffat,et al.  Superconformal Electrodeposition of Silver from a KAg ( CN ) 2 ­ KCN ­ KSeCN Electrolyte , 2003 .

[6]  A. Bard,et al.  The Decomposition of the Sulfonate Additive Sulfopropyl Sulfonate in Acid Copper Electroplating Chemistries , 2003 .

[7]  M. Porter,et al.  Origin of the multiple voltammetric desorption waves of long-chain alkanethiolate monolayers chemisorbed on annealed gold electrodes , 2000 .

[8]  T. Moffat,et al.  Superconformal Electrodeposition Using Derivitized Substrates , 2002 .

[9]  K. Kontturi,et al.  Influence of thiourea and thiourea ageing on the electrodeposition of copper from acid sulfate solutions studied by the ring-disc technique , 1996 .

[10]  CHANGES IN THE NEAR-ELECTRODE CONCENTRATION OF CU+ IONS UNDER THE EFFECT OF BRIGHTENERS IN SULFATE ELECTROLYTES , 1996 .

[11]  T. Moffat,et al.  Superconformal Electrodeposition of Copper , 2001 .

[12]  P. Vereecken,et al.  Electrochemical behaviour of (1 0 0) GaAs in copper(II)-containing solutions , 1996 .

[13]  W. Paik,et al.  Adsorption of self-assembling sulfur compounds through electrochemical reactions: Effects of potential, acid and oxidizing agents , 2001 .

[14]  S. Bruckenstein,et al.  A ring-disk electrode study of the deposition and stripping of thin copper films at platinum in sulfuric acid , 1968 .

[15]  M. Yokoi,et al.  Mechanism of the Electrodeposition and Dissolution of Copper in an Acid Copper Sulfate Bath I. The Behavior of Intermediate, Cu + , 1983 .

[16]  John E. Bonevich,et al.  A Simple Equation for Predicting Superconformal Electrodeposition in Submicrometer Trenches , 2001 .

[17]  Soo‐Kil Kim,et al.  Catalytic behavior of 3-mercapto-1-propane sulfonic acid on Cu electrodeposition and its effect on Cu film properties for CMOS device metallization , 2003 .

[18]  J. Bonevich,et al.  Superconformal Electrodeposition of Copper in 500–90 nm Features , 2000 .

[19]  M. Hayase,et al.  Preferential Copper Electrodeposition at Submicrometer Trenches by Consumption of Halide Ion , 2003 .

[20]  M. Yokoi,et al.  Mechanism of the Electrodeposition and Dissolution of Copper in an Acid Copper Sulfate Bath IV. Acceleration Mechanism in the Presence of Cl - Ions , 1983 .

[21]  Alan C. West,et al.  A Superfilling Model that Predicts Bump Formation , 2001 .

[22]  A. West,et al.  Leveling and Microstructural Effects of Additives for Copper Electrodeposition , 1999 .

[23]  D. Pletcher,et al.  The chemistry of the additives in an acid copper electroplating bath: Part III. The mechanism of brightening by 4,5-dithia-octane-1, 8-disulphonic acid , 1992 .

[24]  Thomas P. Moffat,et al.  Superconformal Electrodeposition of Copper [Electrochemical and Solid-State Letters, 4, C26 (2001)] , 2001 .

[25]  Derek Pletcher,et al.  The chemistry of the additives in an acid copper electroplating bath: Part I. Polyethylene glycol and chloride ion , 1992 .

[26]  Thomas P. Moffat,et al.  Modeling Superconformal Electrodeposition Using The Level Set Method , 2003 .

[27]  Alan C. West,et al.  Copper Deposition in the Presence of Polyethylene Glycol I. Quartz Crystal Microbalance Study , 1998 .

[28]  Richard C. Alkire,et al.  Simulation of Shape Evolution during Electrodeposition of Copper in the Presence of Additive , 2001 .

[29]  V. Jović,et al.  Copper electrodeposition from a copper acid baths in the presence of PEG and NaCl , 2001 .

[30]  Panayotis C. Andricacos,et al.  Damascene copper electroplating for chip interconnections , 1998, IBM J. Res. Dev..

[31]  D. M. Soares,et al.  Copper ion reduction catalyzed by chloride ions , 2002 .

[32]  T. Moffat,et al.  Interconnect Fabrication by Superconformal Iodine-Catalyzed Chemical Vapor Deposition of Copper , 2003 .

[33]  M. Hayase,et al.  Copper Bottom-up Deposition by Breakdown of PEG-Cl Inhibition , 2002 .

[34]  A. West.  Theory of filling of high-aspect ratio trenches and vias in presence of additives , 2000 .

[35]  T. Cale,et al.  Modeling Pattern Density Dependent Bump Formation in Copper Electrochemical Deposition , 2003 .