Thermoelastohydrodynamic Analysis of Spur Gears with Consideration of Surface Roughness

Thermoelastohydrodynamic lubrication (TEHL) analysis for spur gears with consideration of surface roughness is presented. The model is based on Johnson’s load sharing concept where a portion of load is carried by fluid film and the rest by asperities. The solution algorithm consists of two parts. In the first part, the scaling factors and film thickness with consideration of thermal effect are determined. Then, simplified energy equation is solved to predict the surfaces and film temperature. Once the film temperature is known, the viscosity of the lubricant and therefore friction coefficient are calculated. The predicted results for the friction coefficient based on this algorithm are in agreement with published experimental data as well as those of EHL simulations for rough line contact. First point of contact is the point where the asperities carry a large portion of load and the lubricant has the highest temperature and the lowest thickness. Also, according to experimental investigations, the largest amount of wear in spur gears happens in the first point of contact. Effect of speed on film temperature and friction coefficient has been studied. As speed increases, more heat is generated and therefore film temperature will rise. Film temperature rise will result in reduction of lubricant viscosity and consequently decrease in friction coefficient. Surface roughness effect on friction coefficient is also studied. An increase in surface roughness will increase the asperities interaction and therefore friction coefficient will rise.

[1]  H. I. Waterman,et al.  The Viscosity-Temperature-Pressure Relationship of Lubricating Oils and Its Correlation With Chemical Constitution , 1963 .

[2]  T. A. Harris,et al.  Rolling Bearing Analysis , 1967 .

[3]  J. Greenwood,et al.  The Contact of Two Nominally Flat Rough Surfaces , 1970 .

[4]  J. A. Greenwood,et al.  A simple theory of asperity contact in elastohydro-dynamic lubrication , 1972 .

[5]  Influence of Surface Roughness and Its Orientation on Partial Elastohydrodynamic Lubrication of Rollers , 1983 .

[6]  Farshid Sadeghi,et al.  Thermal Elastohydrodynamic Lubrication of Rough Surfaces , 1990 .

[7]  Farshid Sadeghi,et al.  Thermal Elastohydrodynamic Lubrication of Rolling/Sliding Contacts , 1990 .

[8]  H. Moes,et al.  Optimum similarity analysis with applications to elastohydrodynamic lubrication , 1992 .

[9]  Michael M. Khonsari,et al.  Thermal Elastohydrodynamic Analysis Using a Generalized Non-Newtonian Formulation With Application to Bair-Winer Constitutive Equation , 1994 .

[10]  Rong-Tsong Lee,et al.  An Efficient Algorithm for Thermal Elastohydrodynamic Lubrication Under Rolling/Sliding Line Contacts , 1994 .

[11]  M. Khonsari,et al.  Application of Transient Elastohydrodynamic Lubrication Analysis for Gear Transmissions , 1995 .

[12]  R. Larsson.  Transient non-Newtonian elastohydrodynamic lubrication analysis of an involute spur gear , 1997 .

[13]  Dirk J. Schipper,et al.  Calculation of Stribeck Curves for Line Contacts , 2000 .

[14]  Dirk J. Schipper,et al.  Deformation of Rough Line Contacts , 1999 .

[15]  Michael M. Khonsari,et al.  The Stribeck Curve: Experimental Results and Theoretical Prediction , 2006 .

[16]  Michael M. Khonsari,et al.  Performance of Spur Gears Considering Surface Roughness and Shear Thinning Lubricant , 2008 .