Dynamics of flow control in an emulated boundary layer-ingesting offset diffuser

[1]  Ahmad Vakili,et al.  Flow Control In A Diffusing S-Duct , 1985 .

[2]  Michael Amitay,et al.  Separation Control in Duct Flows , 2002 .

[3]  R. H. Liebeck,et al.  Design of the Blended Wing Body Subsonic Transport , 2002 .

[4]  C. T. Ting,et al.  A 727 airplane center duct inlet low speed performance confirmation model test for refanned JT8D engines, phase 2 , 1973 .

[5]  David L. Daggett,et al.  Blended Wing Body Systems Studies: Boundary Layer Ingestion Inlets with Active Flow Control , 2013 .

[6]  Onkar Sahni,et al.  Experimental and Numerical Investigation of Active Control of Inlet Ducts , 2009 .

[7]  Joachim Kurzke.  Effects of Inlet Flow Distortion on the Performance of Aircraft Gas Turbines , 2008 .

[8]  Ari Glezer,et al.  Controlled Streamwise Vorticity in Diffuser Boundary Layer using Hybrid Synthetic Jet Actuation , 2009 .

[9]  Michel Stanislas,et al.  Control of a decelerating boundary layer. Part 1: Optimization of passive vortex generators , 2006 .

[10]  B. A. Reichert,et al.  Improving curved subsonic diffuser performance with vortex generators , 1996 .

[11]  Brian G. Allan,et al.  Boundary-Layer-Ingesting Inlet Flow Control , 2013 .

[12]  P. Bradshaw,et al.  The Flow in S-shaped Ducts , 1972 .

[13]  Leroy H. Smith.  Wake ingestion propulsion benefit , 1993 .

[14]  Jean-Christophe Béra,et al.  Synthetic jet control for flows in a diffuser: vectoring, spreading and mixing enhancement , 2003 .

[15]  Ari Glezer,et al.  Transitory Separation Control over a Stalled Airfoil , 2009 .

[16]  Edward M. Greitzer,et al.  1997 Best Paper Award—Controls and Diagnostics Committee: Active Stabilization of Rotating Stall and Surge in a Transonic Single-Stage Axial Compressor , 1998 .

[17]  A. Johansson,et al.  A Reynolds stress closure description of separation control with vortex generators in a plane asymmetric diffuser , 2007 .

[18]  B. H. Anderson,et al.  Study on vortex generator flow control for the management of inlet distortion , 1993 .

[19]  Leonel Serrano,et al.  Blended Wing Body (Bwb) Boundary Layer Ingestion (Bli) Inlet Configuration and System Studies , 2013 .

[20]  Design and evaluation of screens to produce multi-cycle plus or minus 20% amplitude sinusoidal velocity profiles , 1974 .

[21]  Robert Liebeck,et al.  An experimental investigation of boundary layer ingestion in a diffusing S-duct with and without passive flow control , 1999 .

[22]  P. Holmes,et al.  The Proper Orthogonal Decomposition in the Analysis of Turbulent Flows , 1993 .

[23]  Ahmad Vakili,et al.  Measurements of compressible secondary flow in a circular S-duct , 1983 .

[24]  Theodore H. Okiishi,et al.  An experimental investigation of the flow in a diffusing S-duct , 1992 .

[25]  R. Burdisso,et al.  Effectiveness of a Serpentine Inlet Duct Flow Control Technique at Design and Off-Design Simulated Flight Conditions , 2006 .

[26]  Serge Tournier,et al.  Flow analysis and control in a subsonic inlet , 2005 .

[27]  B. H. Anderson,et al.  Optimal Micro-Vane Flow Control for Compact Air Vehicle Inlets , 2013 .

[28]  A. Glezer,et al.  A high-speed, compressible synthetic jet , 2006 .

[29]  B. Allan,et al.  Experimental and Computational Evaluation of Flush-Mounted, S-Duct Inlets , 2004 .

[30]  Wing Ng,et al.  Active Flow Control of a Boundary Layer-Ingesting Serpentine Inlet Diffuser , 2013 .

[31]  John C. Lin,et al.  Review of research on low-profile vortex generators to control boundary-layer separation , 2002 .

[32]  Mori Mani,et al.  Active "Fail Safe" Micro-Array Flow Control For Advanced Embedded Propulsion Systems , 2009 .

[33]  Ari Glezer,et al.  Distortion Management in a Boundary Layer Ingestion Inlet Diffuser Using Hybrid Flow Control , 2014 .

[34]  Robert Liebeck,et al.  An experimental study of the effect of offset on thick boundary layers flowing inside diffusing ducts , 1999 .

[35]  A. Jirásek,et al.  Developement and application in design strategy for design of vortex generator flow control in inlets , 2006 .