Quantifying inhomogeneity of lithium ion battery electrodes and its influence on electrochemical performance

This paper presents an approach to quantify microstructural inhomegeneity in lithium ion battery electrodes over multiple length scales and examines the impact of this microstructural inhomogeneity on electrochemical performance. Commerical graphite anodes are investigated because graphite remains the anode material of choice due to its low cost, mechanical robustness, and suitable electrochemical properties. At the same time, the graphite anode often plays a role in cell degradation and failure, as lithium plating can occur on the graphite anode during charge, when unfavorable microstructure in the graphite electrode leads to a large overpotential. Here, three-dimensional representations of four different commercial anodes obtained with X-ray tomographic microscopy are statistically analyzed to quantify the microstructural inhomogeneity that is commonly present in lithium ion battery electrodes. Electrochemical simulations on the digitalized microstructures are performed to isolate and understand the influence of different types of microstructural inhomogeneity on battery performance. By understanding how distributions in particle size and shape or slurry and electrode processing cause microstructural inhomogeneity and impact performance, it is possible to determine the extent to which homogeneity should be prioritized for specific applications and how homogeneity could be achieved through smart material selection and processing. © The Author(s) 2018. Published by ECS. This is an open access article distributed under the terms of the Creative Commons Attribution 4.0 License (CC BY, http://creativecommons.org/licenses/by/4.0/), which permits unrestricted reuse of the work in any medium, provided the original work is properly cited. [DOI: 10.1149/2.0311802jes]

[1]  M. Ebner,et al.  Communication—Technique for Visualization and Quantification of Lithium-Ion Battery Separator Microstructure , 2016 .

[2]  Jitendra Malik,et al.  Scale-Space and Edge Detection Using Anisotropic Diffusion , 1990, IEEE Trans. Pattern Anal. Mach. Intell..

[3]  Yasuhiro Fukunaka,et al.  Li dendrite growth and Li+ ionic mass transfer phenomenon , 2011 .

[4]  Stephen J. Harris,et al.  In-situ observation of inhomogeneous degradation in large format Li-ion cells by neutron diffraction , 2013 .

[5]  M. Doyle,et al.  Simulation and Optimization of the Dual Lithium Ion Insertion Cell , 1994 .

[6]  Hubert A. Gasteiger,et al.  Tortuosity Determination of Battery Electrodes and Separators by Impedance Spectroscopy , 2016 .

[7]  Jochen Zausch,et al.  Thermodynamic consistent transport theory of Li-ion batteries , 2011 .

[8]  Ann Marie Sastry,et al.  Micro-Scale Modeling of Li-Ion Batteries: Parameterization and Validation , 2012 .

[9]  Michael A. Danzer,et al.  Nondestructive detection, characterization, and quantification of lithium plating in commercial lithium-ion batteries , 2014 .

[10]  P. Gasser,et al.  Redox cycling of Ni-YSZ anodes for solid oxide fuel cells: influence of tortuosity, constriction and percolation factors on the effective transport properties , 2013 .

[11]  J. Newman,et al.  Porous‐electrode theory with battery applications , 1975 .

[12]  Wei Zhang,et al.  Visualizing the chemistry and structure dynamics in lithium-ion batteries by in-situ neutron diffraction , 2012, Scientific Reports.

[13]  Martin D. Levine,et al.  Visual Saliency Based on Scale-Space Analysis in the Frequency Domain , 2013, IEEE Transactions on Pattern Analysis and Machine Intelligence.

[14]  P. M. Heertjes,et al.  Analysis of diffusion in macroporous media in terms of a porosity, a tortuosity and a constrictivity factor , 1974 .

[15]  F. Marone,et al.  X‐Ray Tomography of Porous, Transition Metal Oxide Based Lithium Ion Battery Electrodes , 2013 .

[16]  Jochen Zausch,et al.  Multiscale modeling of lithium ion batteries: thermal aspects , 2015, Beilstein journal of nanotechnology.

[17]  Charles W. Monroe,et al.  Direct in situ measurements of Li transport in Li-ion battery negative electrodes , 2009 .

[18]  Ralph E. White,et al.  Capacity Fade Mechanisms and Side Reactions in Lithium‐Ion Batteries , 1998 .

[19]  Rüdiger Kötz,et al.  Capacitance limits of high surface area activated carbons for double layer capacitors , 2005 .

[20]  M. Yoshio,et al.  Improvement of natural graphite as a lithium-ion battery anode material, from raw flake to carbon-coated sphere , 2004 .

[21]  Martin Ebner,et al.  Tool for Tortuosity Estimation in Lithium Ion Battery Porous Electrodes , 2015 .

[22]  J. C. Burns,et al.  In-Situ Detection of Lithium Plating Using High Precision Coulometry , 2015 .

[23]  P. Shearing,et al.  Particle Size Polydispersity in Li-Ion Batteries , 2014 .

[24]  Jeff Dahn,et al.  Studies of Lithium Intercalation into Carbons Using Nonaqueous Electrochemical Cells , 1990 .

[25]  Marco Stampanoni,et al.  Determining the uncertainty in microstructural parameters extracted from tomographic data , 2018 .

[26]  Marshall C. Smart,et al.  Lithium Plating Behavior in Lithium-Ion Cells , 2010 .

[27]  Roland Zengerle,et al.  How Coarsening the 3D Reconstruction of a Porous Material Influences Diffusivity and Conductivity Values , 2012 .

[28]  T. Lindeberg,et al.  Scale-Space Theory : A Basic Tool for Analysing Structures at Different Scales , 1994 .

[29]  Nigel P. Brandon,et al.  Characterization of the 3-dimensional microstructure of a graphite negative electrode from a Li-ion battery , 2010 .

[30]  P. Novák,et al.  Graphites for lithium-ion cells : The correlation of the first-cycle charge loss with the Brunauer-Emmett-Teller surface area , 1998 .

[31]  Jochen Zausch,et al.  Thermodynamic derivation of a Butler-Volmer model for intercalation in Li-ion batteries , 2013 .

[32]  Norman Epstein,et al.  On tortuosity and the tortuosity factor in flow and diffusion through porous media , 1989 .

[33]  M. Ebner,et al.  Electrodes: Tortuosity Anisotropy in Lithium‐Ion Battery Electrodes (Adv. Energy Mater. 5/2014) , 2014 .

[34]  Doron Aurbach,et al.  Challenges in the development of advanced Li-ion batteries: a review , 2011 .

[35]  Sandrine Marceau,et al.  Durability of Bio-based Concretes, Chapitre 8. In: S. Amziane, F. Collet (Eds) Bio-aggregates Based Building Materials , 2017 .

[36]  Marshall C. Smart,et al.  Effects of Electrolyte Composition on Lithium Plating in Lithium-Ion Cells , 2011 .

[37]  Rajeswari Chandrasekaran,et al.  Quantification of contributions to the cell overpotential during galvanostatic discharge of a lithium-ion cell , 2014 .

[38]  F. Peyrin,et al.  Microstructure and transport properties of porous building materials. II: Three-dimensional X-ray tomographic studies , 2000 .

[39]  A. J. Smith,et al.  A High Precision Study of the Coulombic Efficiency of Li-Ion Batteries , 2010 .

[40]  Martin Winter,et al.  XPS studies of graphite electrode materials for lithium ion batteries , 2000 .

[41]  Jeffrey Thomas Remillard,et al.  Local State‐of‐Charge Mapping of Lithium‐Ion Battery Electrodes , 2011 .

[42]  K. Zaghib,et al.  Effect of particle morphology on lithium intercalation rates in natural graphite , 2003, Journal of Power Sources.

[43]  Peng Lu,et al.  Effects of Inhomogeneities—Nanoscale to Mesoscale—on the Durability of Li-Ion Batteries , 2013 .

[44]  Nigel P. Brandon,et al.  Local Tortuosity Inhomogeneities in a Lithium Battery Composite Electrode , 2011 .

[45]  D. Wheeler,et al.  A Combination of X‐Ray Tomography and Carbon Binder Modeling: Reconstructing the Three Phases of LiCoO2 Li‐Ion Battery Cathodes , 2014 .