Low Temperature Combustion – A Thermodynamic Pathway to High Efficiency Engines

This article makes the argument that compression ignition combustion processes that are “flameless” with volumetric energy release, described as Low Temperature Combustion (LTC), are a thermodynamic pathway to maximizing the efficiency of reciprocating piston, internal combustion engines. The argument is built from the foundation of determining the maximum theoretical efficiency for an IC Engine and then identifying the irreversibilities associated with the various in-cylinder processes. Low Temperature Combustion minimizes the sum of the irreversibilities for work generation from incylinder processes. The underlying objective of Low Temperature Combustion is to keep in-cylinder temperatures low through volumetric energy release via auto-ignition of dilute air fuel mixtures, as opposed to flame propagation. Because LTC depends on autoignition, the methods used to achieve it are dependent on the auto-ignition characteristics of the fuel being used. Differences in physical and auto-ignition characteristics of fuels mandate different approaches for establishing and controlling LTC. It has become common to label the different approaches with a descriptive acronym, leading to a proliferation of terms such as HCCI, PCCI, CAI, etc. Because the energy release is volumetric it is a challenge to operate at low loads with good combustion stability, and at high loads without excessive rates of pressure rise. Good progress is being made addressing these challenges but doing so will put added burden on the gas exchange and control systems of the engine.

[1]  Noam Lior,et al.  SECOND-LAW ANALYSIS OF AN IDEAL OTTO CYCLE , 1988 .

[2]  Bengt Johansson,et al.  Investigation and Comparison of Multi Cylinder Partially Premixed Combustion Characteristics for Diesel and Gasoline Fuels , 2011 .

[3]  Akihiko Minato,et al.  Investigation of premixed lean diesel combustion with ultra high pressure injection , 2005 .

[4]  K. Akihama,et al.  Mechanism of the Smokeless Rich Diesel Combustion by Reducing Temperature , 2001 .

[5]  Dennis N. Assanis,et al.  Comparing Enhanced Natural Thermal Stratification Against Retarded Combustion Phasing for Smoothing of HCCI Heat-Release Rates , 2004 .

[6]  Kazutoshi Mori,et al.  Premixed Compression Ignition (PCI) Combustion for Simultaneous Reduction of NOx and Soot in Diesel Engine , 2004 .

[7]  Roger B. Krieger,et al.  Gasoline DICI Engine Operation in the LTC Regime Using Triple- Pulse Injection , 2012 .

[8]  C. H. Schleyer,et al.  Effects of Fuel Property Changes on Heavy-Duty HCCI Combustion , 2007 .

[9]  Shuji Kimura,et al.  New Combustion Concept for Ultra-Clean and High-Efficiency Small DI Diesel Engines , 1999 .

[10]  D. Splitter,et al.  Experiments and Modeling of Dual-Fuel HCCI and PCCI Combustion Using In-Cylinder Fuel Blending , 2009 .

[11]  R. O’Hayre,et al.  Fuel Cell Fundamentals , 2005 .

[12]  Hans-Erik Ångström,et al.  Advantages of Fuels with High Resistance to Auto-ignition in Late-injection, Low-temperature, Compression Ignition Combustion , 2006 .

[13]  Terukazu Nishimura,et al.  Dual Mode Combustion Concept With Premixed Diesel Combustion by Direct Injection Near Top Dead Center , 2003 .

[14]  K. Hoag,et al.  An appraisal of advanced engine concepts using second law analysis techniques , 1984 .

[15]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[16]  John E. Dec,et al.  Boosted HCCI - Controlling Pressure-Rise Rates for Performance Improvements using Partial Fuel Stratification with Conventional Gasoline , 2011 .

[17]  W. Marsden.  I and J , 2012 .

[18]  Hans-Erik Ångström,et al.  Partially pre-mixed auto-ignition of gasoline to attain low smoke and low NOx at high load in a compression ignition engine and comparison with a diesel fuel , 2007 .