A MODEL FOR THE SPREAD OF FIRE ACROSS A FUEL BED INCORPORATING THE EFFECTS OF WIND AND SLOPE

ABSTRACT A two-dimensional nonstationary model of a fire spreading across a bed of fuel is proposed, incorporating the effects of wind and slope. The contributions of both radiative and convective preheating ahead of the fire front are included. The radiation impinging on the top of the fuel bed is determined, assuming the flame is a radiant surface. Convective heat transfer in the fuel layer is considered using a simplified description of the flow through the fuel bed. Model predictions are compared to laboratory-scale experiments. Dedicated experiments were carried out for horizontal fire spread in still air across beds of pine needles to measure flame and fire front properties using infrared camera, thermocouples, and heat flux sensors. Experiments conducted under wind and slope conditions are also considered.

[1]  R. Weber,et al.  Analytical models for fire spread due to radiation , 1989 .

[2]  C. Baukal,et al.  Oxygen-enhanced/natural gas flame radiation , 1997 .

[3]  Thomas G. Peterson,et al.  Flame spread through porous fuels , 1973 .

[4]  T. Kubota,et al.  Visible structure of buoyant diffusion flames , 1985 .

[5]  Jean-Luc Dupuy,et al.  Slope and Fuel Load Effects on Fire Behavior: Laboratory Experiments in Pine Needles Fuel Beds , 1995 .

[6]  Gilles Parent,et al.  Numerical simulation of a water spray—Radiation attenuation related to spray dynamics , 2007 .

[7]  R. C. Rothermel,et al.  Influence of moisture and wind upon the characteristics of free-burning fires , 1965 .

[8]  Paul-Antoine Santoni,et al.  The contribution of radiant heat transfer to laboratory-scale fire spread under the influences of wind and slope , 2001 .

[9]  J. Balbi,et al.  Proposal for Theoretical Improvement of Semi-Physical Forest Fire Spread Models Thanks to a Multiphase Approach: Application to a Fire Spread Model Across a Fuel Bed , 2001 .

[10]  O. Séro-Guillaume,et al.  Modelling forest fires. Part II: reduction to two-dimensional models and simulation of propagation , 2002 .

[11]  M. Larini,et al.  A multiphase formulation for fire propagation in heterogeneous combustible media , 1998 .

[12]  J. Winkel,et al.  Infrared Measurements of Energy Release and Flame Temperatures of Forest Fires , 1998 .

[13]  Gregory S. Biging,et al.  A Qualitative Comparison of Fire Spread Models Incorporating Wind and Slope Effects , 1997, Forest Science.

[14]  F. Albini,et al.  A model for the wind-blown flame from a line fire , 1981 .

[15]  Paul-Antoine Santoni,et al.  Validation Study of a Two-Dimensional Model of Fire Spread Across a Fuel Bed , 2000 .

[16]  Andrew L. Sullivan,et al.  A semi-transparent model of bushfire flames to predict radiant heat flux , 2004 .

[17]  Jorge C. S. André,et al.  Modelling the spread of a straight and steady fire front through a horizontal porous fuel bed without wind. , 2002 .

[18]  Paul-Antoine Santoni,et al.  Mass loss rate modelling for a spreading fire: proposal of an experimental device , 2001 .

[19]  J. Balbi,et al.  Coupling of a simplified flow with a phenomenological fire spread model , 2002 .

[20]  P. Blackshear,et al.  Heat Transfer in Fires: Thermophysics, Social Aspects, Economic Impact , 1974 .

[21]  F. Steward,et al.  Flame spread through randomly packed fuel particles , 1969 .

[22]  Dominique Morvan,et al.  Firespread through fuel beds: Modeling of wind-aided fires and induced hydrodynamics , 2000 .

[23]  W. Fons,et al.  Analysis of Fire Spread in Light Forest Fuels , 1946 .

[24]  M. Pinar Mengüç,et al.  Thermal Radiation Heat Transfer , 2020 .

[25]  G. Cox,et al.  Combustion fundamentals of fire , 1995 .

[26]  Jose L. Torero,et al.  Average centreline temperatures of a buoyant pool fire obtained by image processing of video recordings , 1995 .

[27]  Andrew L. Sullivan,et al.  A review of radiant heat flux models used in bushfire applications , 2003 .

[28]  J. Balbi,et al.  Dynamic modelling of upslope fire growth , 1999 .

[29]  J. Sacadura.  Radiative heat transfer in fire safety science , 2005 .

[30]  Paul-Antoine Santoni,et al.  Fire Front Width Effects on Fire Spread Across a Laboratory Scale Sloping Fuel Bed , 2001 .

[31]  Albert Simeoni,et al.  Reduction of a multiphase formulation to include a simplified flow in a semi-physical model of fire spread across a fuel bed , 2003 .

[32]  Gary A. Morris,et al.  Rate of Spread of Free-Burning Fires in Woody Fuels in a Wind Tunnel , 1998 .

[33]  Yuji Hasemi,et al.  Fuel Shape Effect on the Deterministic Properties of Turbulent Diffusion Flames , 1989 .

[34]  Paul-Antoine Santoni,et al.  Measurement of fluctuating temperatures in a continuous flame spreading across a fuel bed using a double thermocouple probe , 2002 .

[35]  M. Sharan,et al.  Statistical evaluation of sigma schemes for estimating dispersion in low wind conditions , 1996 .

[36]  F. H. Harlow,et al.  Use of transport models for wildfire behavior simulations , 1998 .

[37]  E. A. Catchpole,et al.  A model for the steady spread of fire through a homogeneous fuel bed. , 2002 .

[38]  B. Mccaffrey.  Purely buoyant diffusion flames :: some experimental results , 1979 .

[39]  Domingos Xavier Viegas,et al.  Forest fire propagation , 1998, Philosophical Transactions of the Royal Society of London. Series A: Mathematical, Physical and Engineering Sciences.

[40]  J. Balbi,et al.  Dynamic modelling of fire spread across a fuel bed , 1999 .

[41]  Albert Simeoni,et al.  Fire spread across pine needle fuel beds: characterization of temperature and velocity distributions within the fire plume , 2004 .

[42]  J.-L Dupuy.  Testing Two Radiative Physical Models for Fire Spread Through Porous Forest Fuel Beds , 2000 .