Abstract This paper presents an analytical study about the viscoelastic time-dependent (creep) behavior of pultruded GFRP elements made of polyester and E-glass fibers. Experimental results reported in Part 1 are firstly used for material characterization by means of empirical and phenomenological formulations – a good general agreement is obtained using the following analytical models: (i) Findley’s power law, (ii) Bruger–Kelvin model and (iii) Prony–Dirichlet series. Based on accelerated characterization methodology – Time-Stress Superposition Principle (TSSP) coupled with Findley’s law, for a reference stress of 20% of the material ultimate stress, an elastic deformation increase of 30% is obtained after 50,000 h. The creep parameters and deformation estimated by using the Findley’s model derivations indicate a consistent prediction of time-dependent deformation and viscoelastic properties of the two types of elements analysed – laminates and beam. A straightforward formulation to predict the time-dependent elastic modulus is applied, showing that the flexural stiffness should be reduced by 25% of its initial value after 1-year and as much as 50% after 50-years. Similarly, the power law coupled to Euler’s classical beam theory suggests a reasonable adaptability to the creep phenomenon in the linear regime and proved to provide accurate predictions for deflections under flexural loading up to 40% of the ultimate strength. After 50 years, under normal service load level (1/3 of the failure load), the total creep deflection will attain almost twice the initial deflection. If taking into account the shear deformation (Timoshenko’s postulated) of the full-size element with “effective” stiffness properties such estimate is reduced nearly 25%.
[1]
R. Guedes,et al.
Experimental and theoretical study of the creep behavior of GFRP-reinforced polymer concrete
,
2004
.
[2]
David W. Scott,et al.
Creep Behavior of Fiber-Reinforced Polymeric Composites: A Review of the Technical Literature
,
1995
.
[3]
S. Yen,et al.
Accelerated characterization of creep response of an off-axis composite material
,
1990
.
[4]
L. Bank.
Composites for Construction: Structural Design with FRP Materials
,
2006
.
[5]
Fernando A. Branco,et al.
Glass Fibre Reinforced Polymer Pultruded Flexural Members: Assessment of Existing Design Methods
,
2010
.
[6]
W. Findley,et al.
26-Year creep and recovery of poly(vinyl chloride) and polyethylene
,
1987
.
[7]
Robert L. Yuan,et al.
TIME-DEPENDENT DEFORMATION OF PULTRUDED FIBER REINFORCED POLYMER COMPOSITE COLUMNS
,
2003
.
[8]
J. Mottram.
Short- and long-term structural properties of pultruded beam assemblies fabricated using adhesive bonding
,
1993
.
[11]
D. Scott,et al.
Compression creep of a pultruded E-glass/vinylester composite
,
1998
.
[12]
T. Keller.
USE OF FIBRE REINFORCED POLYMERS IN BRIDGE CONSTRUCTION
,
2003
.
[13]
Lawrence C. Bank,et al.
Creep and failure of a full-size fiber-reinforced plastic pultruded frame☆
,
1992
.