The intra-push velocity profile of the over-ground racing wheelchair sprint start.

The aim of this study was to analyse the first six pushes of a sprint start in over-ground racing wheelchair propulsion. One international male wheelchair athlete (age=28 years; body mass=60.6 kg; racing classification=T4) performed maximal over-ground sprint trials, over approximately 10 m, in his own racing wheelchair fitted with a velocometer. Each trial was filmed at 200 Hz using a "Pan and Tilt" system. Eight trials were manually digitised at 100 Hz. Raw co-ordinate data were smoothed and differentiated using a quintic spline routine. Across the period from pushes one to six the duration of each push cycle decreased (0.82+/-0.02-0.45+/-0.01 s) with the mean duration of the propulsive phase decreasing from 0.62+/-0.02 to 0.21+/-0.01 s and the recovery phase increasing from 0.20+/-0.01 to 0.24+/-0.02 s. The push-rim was contacted progressively closer to top dead centre and released progressively closer to bottom dead centre with each push. The data indicate that peak velocity occurred after release. The main findings of this study support the observation that racing wheelchair sprint propulsion is a complex form of locomotion and cannot be described accurately by using just the established definitions of a propulsive and a recovery phase.

[1]  R A Cooper,et al.  Projection of the point of force application onto a palmar plane of the hand during wheelchair propulsion. , 1996, IEEE transactions on rehabilitation engineering : a publication of the IEEE Engineering in Medicine and Biology Society.

[2]  V L Goosey,et al.  Symmetry of the elbow kinematics during racing wheelchair propulsion. , 1998, Ergonomics.

[3]  A. Beckett,et al.  AKUFO AND IBARAPA. , 1965, Lancet.

[4]  Herman J. Woltring,et al.  A fortran package for generalized, cross-validatory spline smoothing and differentiation , 1986 .

[5]  Mary M. Rodgers,et al.  Three-Dimensional Dynamic Analysis of Wheelchair Propulsion , 1998 .

[6]  R A Cooper,et al.  Methods for determining three-dimensional wheelchair pushrim forces and moments: a technical note. , 1997, Journal of rehabilitation research and development.

[7]  K. Roeleveld,et al.  Differences in performance between trained and untrained subjects during a 30-s sprint test in a wheelchair ergometer , 2004, European Journal of Applied Physiology and Occupational Physiology.

[8]  Jerry Wilkerson,et al.  A Kinematic Analysis of 800-Meter Wheelchair-Racing Techniques , 1988 .

[9]  K D Coutts.  Kinematics of sport wheelchair propulsion. , 1990, Journal of rehabilitation research and development.

[10]  Y C Vanlandewijck,et al.  Wheelchair propulsion efficiency: movement pattern adaptations to speed changes. , 1994, Medicine and science in sports and exercise.

[11]  H E Veeger,et al.  Effectiveness of force application in manual wheelchair propulsion in persons with spinal cord injuries. , 1998, American journal of physical medicine & rehabilitation.

[12]  D. Theisen,et al.  Wheelchair Propulsion Biomechanics , 2001, Sports medicine.

[13]  A. Lees,et al.  The interpretation of relative momentum data to assess the contribution of the free limbs to the generation of vertical velocity in sports activities. , 1996, Journal of sports sciences.

[14]  L. V. D. van der Woude,et al.  Anaerobic power output and propulsion technique in spinal cord injured subjects during wheelchair ergometry. , 1994, Journal of rehabilitation research and development.

[15]  N E Fowler,et al.  A telemetry-based velocometer to measure wheelchair velocity. , 2003, Journal of biomechanics.

[16]  V L Goosey,et al.  Effect of push frequency on the economy of wheelchair racers. , 2000, Medicine and science in sports and exercise.

[17]  JoAnne K. Gronley,et al.  Shoulder Joint Kinetics During the Push Phase of Wheelchair Propulsion , 1998, Clinical orthopaedics and related research.

[18]  C Delecluse,et al.  Influence of Strength Training on Sprint Running Performance , 1997, Sports medicine.

[19]  L G Carlton,et al.  Effect of resistance load on biomechanical characteristics of racing wheelchair propulsion over a roller system. , 2000, Journal of biomechanics.

[20]  L G Carlton,et al.  Biomechanical comparison of two racing wheelchair propulsion techniques. , 2001, Medicine and science in sports and exercise.

[21]  J Lieh,et al.  Biomechanics of wheelchair propulsion during fatigue. , 1994, Archives of physical medicine and rehabilitation.

[22]  D. Altman,et al.  STATISTICAL METHODS FOR ASSESSING AGREEMENT BETWEEN TWO METHODS OF CLINICAL MEASUREMENT , 1986, The Lancet.

[23]  J. Perry,et al.  The effect of level of spinal cord injury on shoulder joint kinetics during manual wheelchair propulsion. , 2001, Clinical biomechanics.

[24]  H E Veeger,et al.  Effect of handrim velocity on mechanical efficiency in wheelchair propulsion. , 1992, Medicine and science in sports and exercise.

[25]  V L Goosey-Tolfrey,et al.  A kinetic analysis of trained wheelchair racers during two speeds of propulsion. , 2001, Medical engineering & physics.

[26]  H E Veeger,et al.  A computerized wheelchair ergometer. Results of a comparison study. , 1992, Scandinavian journal of rehabilitation medicine.