Ion current sensing-based lean blowout detection for a pulse combustor

Abstract In this paper an ion current sensing method is proposed for early detection of lean blowout (LBO) in a pulse combustor. The method was also compared with the pressure measurement method. Near LBO characteristics in the pulse combustor were inferred from ion current and pressure time domain signals recorded for different operating conditions and initially analyzed using the spectral analysis method. As LBO approached, low frequency (below 20 Hz) components were gradually observed and the spectral energy between 0 and 20 Hz gradually increased while the energy of the working frequency components decreased. The ratio of the working frequency components energy fraction over the low frequency components energy fraction could thus be treated as an indicator of LBO, denoted by stability to instability ratio (SIR). The index SIR remained at a high level under stable conditions and decreased steeply when LBO was approached. Based on the ion current sensing method and the prediction index SIR, the gas supply pressure for stable operation in the pulse combustor was suggested to be more than 15.2 kPa. The result shows that the proposed ion current sensing method and the index SIR can help to estimate the LBO limit of the pulse combustor and avert the unexpected LBO. Compared to pressure sensing, ion current sensing was observed to be more sensitive to LBO events, leaving sufficient time for combustion control.

[1]  T. Muruganandam,et al.  Acoustic Sensing and Mitigation of Lean Blow Out in Premixed Flames , 2005 .

[2]  M. Stöhr,et al.  Dynamics of lean blowout of a swirl-stabilized flame in a gas turbine model combustor , 2011 .

[3]  D. Mishra,et al.  Dynamic sensing of blowout in turbulent CNG inverse jet flame , 2015 .

[4]  Yei-Chin Chao,et al.  An experimental investigation of the blowout process of a jet flame , 2000 .

[5]  Alexander B. Fialkov,et al.  Investigations on ions in flames , 1997 .

[6]  Li-jun Yang,et al.  Nonlinear analysis of a pulse combustor model with exhaust decoupler and vent pipe , 2013 .

[7]  R. Anthenien,et al.  ION BASED HIGH-TEMPERATURE PRESSURE SENSOR , 2004 .

[8]  Tim Lieuwen,et al.  Lean Blowout Detection in a Single Nozzle Swirl Cup Combustor , 2004 .

[9]  Ronald K. Hanson,et al.  Active control of lean blowout in a swirl-stabilized combustor using a tunable diode laser , 2007 .

[10]  Ephraim Gutmark,et al.  Real-Time Prediction of Incipient Lean Blowout in Gas Turbine Combustors , 2007 .

[11]  Asok Ray,et al.  Lean Blow-Out Prediction in Gas Turbine Combustors Using Symbolic Time Series Analysis , 2013 .

[12]  Sébastien Candel,et al.  Combustion control and sensors: a review , 2002 .

[13]  Ronald K. Hanson,et al.  Sensing and Control of Combustion Instabilities in Swirl-Stabilized Combustors Using Diode-Laser Absorption , 2006 .

[14]  Lijun Xu,et al.  A chemi-ionization processing approach for characterizing flame flickering behavior , 2015, 2015 IEEE International Instrumentation and Measurement Technology Conference (I2MTC) Proceedings.

[15]  Luck Peerlings,et al.  Flame ion generation rate as a measure of the flame thermo-acoustic response , 2013 .

[16]  T. Lieuwen,et al.  Lean-Blowout and its Sensing in the Presence of Combustion Dynamics in a Premixed Swirl Combustor , 2009 .

[17]  Thomas H. Fletcher,et al.  Observations of Flame Behavior in a Laboratory-Scale Pre-Mixed Natural Gas/Air Gas Turbine Combustor From PLIF Measurements of OH , 2002 .

[18]  Maria Grazia De Giorgi,et al.  Image processing for the characterization of flame stability in a non-premixed liquid fuel burner near lean blowout , 2016 .

[19]  Ronald K. Hanson,et al.  Diode laser-based detection of combustor instabilities with application to a scramjet engine , 2009 .

[20]  P. Dong,et al.  Characteristics of the pulsating flow and heat transfer in an elbow tailpipe of a self-excited Helmholtz pulse combustor , 2016 .

[21]  Tim Lieuwen,et al.  Acoustic Detection of Blowout in Premixed Flames , 2005 .

[22]  Sulabh K. Dhanuka,et al.  Lean-limit combustion instabilities of a lean premixed prevaporized gas turbine combustor , 2011 .

[23]  Rajendra R. Chaudhari,et al.  Flame Color as a Lean Blowout Predictor , 2013 .

[24]  Non-linear dynamics in pulse combustor: A review , 2015 .

[25]  Robert W. Dibble,et al.  Combustion Timing in HCCI Engines Determined by Ion-Sensor: Experimental and Kinetic Modeling , 2005 .

[26]  Nick Collings,et al.  Knock Detection by Means of the Spark Plug , 1986 .

[27]  N. Dam,et al.  Experimental investigation of plasma assisted combustion using a low-swirl burner , 2010 .

[28]  Fabian Mauss,et al.  Local Air-Fuel Ratio Measurements Using the Spark Plug as an Ionization Sensor , 1997 .

[29]  H. F. Calcote.  Mechanisms for the formation of ions in flames , 1957 .

[30]  Jerry Seitzman,et al.  American Institute of Aeronautics and Astronautics 1 CHARACTERIZATION OF EXTINCTION EVENTS NEAR BLOWOUT IN SWIRL-DUMP COMBUSTORS , 2005 .

[31]  Wiebren de Jong,et al.  A state-of-the-art review of pulse combustion: Principles, modeling, applications and R&D issues , 2016 .