Fully Integrated Fault-tolerance for PMSMs in Aviation Applications

An open-circuit fault-tolerant system implementation is presented for sensorless three-phase PMSM drives. The fault-tolerant system uses a fourth inverter leg connected to the motor neutral point, allowing for post-fault two-phase operation. Since the control is sensorless and fault detection is performed by the controller, no additional sensors are required beyond three phase current sensors. Hence, the fault-tolerant system is particularly suitable for highly integrated or compact drive systems. Whilst fault detection and sensorless two-phase control are well documented in existing literature, often little attention is given to the transitional behavior between a fault occurring and post-fault operation. Hence we focus on experimentally testing the fault-tolerant system in its entirety. An open-circuit fault is created during sensorless three-phase operation, causing a transient in the motor torque and speed. The controller rapidly detects the fault, and switches to post-fault control with the faulty leg disabled and the 4th leg connected to the motor neutral. In the test system the fault caused only a 5% dip in motor speed before the speed was smoothly regulated back to the commanded pre-fault speed under the post-fault two-phase control scheme. This fast recovery from a fault condition is particularly beneficial to aviation applications, where even a brief loss of the motor drive may be unacceptable.

[1]  Oskar Wallmark,et al.  Control algorithms for a fault-tolerant PMSM drive , 2007, 31st Annual Conference of IEEE Industrial Electronics Society, 2005. IECON 2005..

[2]  Zi-Qiang Zhu,et al.  Electrical Machines and Drives for Electric, Hybrid, and Fuel Cell Vehicles , 2007, Proceedings of the IEEE.

[3]  F.W. Fuchs,et al.  Performance of diagnosis methods for IGBT open circuit faults in three phase voltage source inverters for AC variable speed drives , 2005, 2005 European Conference on Power Electronics and Applications.

[4]  G. Gateau,et al.  Fault-tolerant inverter for on-board aircraft EHA , 2007, 2007 European Conference on Power Electronics and Applications.

[5]  F.W. Fuchs,et al.  Performance of diagnosis methods for IGBT open circuit faults in voltage source active rectifiers , 2004, 2004 IEEE 35th Annual Power Electronics Specialists Conference (IEEE Cat. No.04CH37551).

[6]  Silverio Bolognani,et al.  Experimental fault-tolerant control of a PMSM drive , 2000, IEEE Trans. Ind. Electron..

[7]  António J. Marques Cardoso,et al.  A New Algorithm for Real-Time Multiple Open-Circuit Fault Diagnosis in Voltage-Fed PWM Motor Drives by the Reference Current Errors , 2013, IEEE Transactions on Industrial Electronics.

[8]  Friedrich W. Fuchs,et al.  Some diagnosis methods for voltage source inverters in variable speed drives with induction machines - a survey , 2003, IECON'03. 29th Annual Conference of the IEEE Industrial Electronics Society (IEEE Cat. No.03CH37468).

[9]  Gary M. Dolny,et al.  IGBT behavior during desat detection and short circuit fault protection , 1998, Proceedings of the 10th International Symposium on Power Semiconductor Devices and ICs. ISPSD'98 (IEEE Cat. No.98CH36212).

[10]  Andrew R. Gibson,et al.  Design and Performance of the NASA SCEPTOR Distributed Electric Propulsion Flight Demonstrator , 2016 .

[11]  Bin Lu,et al.  A Literature Review of IGBT Fault Diagnostic and Protection Methods for Power Inverters , 2008, 2008 IEEE Industry Applications Society Annual Meeting.

[12]  R. Peuget,et al.  Fault detection and isolation on a PWM inverter by knowledge-based model , 1997, IAS '97. Conference Record of the 1997 IEEE Industry Applications Conference Thirty-Second IAS Annual Meeting.

[13]  Behrooz Mirafzal,et al.  Survey of Fault-Tolerance Techniques for Three-Phase Voltage Source Inverters , 2014, IEEE Transactions on Industrial Electronics.

[14]  T.A. Lipo,et al.  A strategy for improving reliability of field oriented controlled induction motor drives , 1991, Conference Record of the 1991 IEEE Industry Applications Society Annual Meeting.

[15]  N. Bianchi,et al.  Innovative Remedial Strategies for Inverter Faults in IPM Synchronous Motor Drives , 2002, IEEE Power Engineering Review.

[16]  Sensorless Vector Control of PM Synchronous Motors During Single-Phase Open-Circuit Faulted Conditions , 2012, IEEE Transactions on Industry Applications.

[17]  A.M.S. Mendes,et al.  Voltage source inverter fault diagnosis in variable speed AC drives, by the average current Park's vector approach , 1999, IEEE International Electric Machines and Drives Conference. IEMDC'99. Proceedings (Cat. No.99EX272).

[18]  A. J. M. Cardoso,et al.  Fast fault detection, isolation and reconfiguration in fault-tolerant permanent magnet synchronous motor drives , 2012, 2012 IEEE Energy Conversion Congress and Exposition (ECCE).