Creepage discharge on insulation barriers in aged power transformers

This paper presents experimental research of creepage discharge on insulation barriers in power transformers. Using point-to-plate electrode configurations under AC voltages creepage discharge is studied for both single flashover breakdown and partial discharge induced failure modes. It is confirmed that the dielectric strength of oil gap will not be reduced with introducing dry new pressboard surface into the oil gap, indeed the flashover breakdown voltage is hardly compromised by introducing aged pressboard with up to 3% moisture. However, increased moisture content in pressboard reduces partial discharge inception voltage (PDIV) significantly, i.e. ~30% PDIV reduction for pressboard of ~3% moisture as compared with dry pressboard. More importantly, high moisture contents in pressboard increase PD activities in oil pores which allow gasses to be trapped inside to develop gaseous channels which eventually lead creepage discharge to breakdown.

[1]  V. Sokolov,et al.  INTERNAL INSULATION FAILURE MECHANISMS OF HV EQUIPMENT UNDER SERVICE CONDITIONS , 2002 .

[2]  J.K. Nelson,et al.  The impulse design of transformer oil-cellulose structures , 2006, IEEE Transactions on Dielectrics and Electrical Insulation.

[3]  O. Lesaint,et al.  Streamer generation and propagation in transformer oil under divergent field conditions , 1987, 1987 Ninth International Conference on Conduction and Breakdown in Dielectric Liquids.

[4]  Kenneth Wechsler,et al.  Electric Breakdown of a Parallel Solid and Liquid Dielectric System , 1961, Transactions of the American Institute of Electrical Engineers. Part III: Power Apparatus and Systems.

[5]  J. K. Nelson,et al.  An assessment of the physical basis for the application of design criteria for dielectric structures , 1989 .

[6]  Gunnar Berg,et al.  Propagation of positive and negative streamers in oil with and without pressboard interfaces , 1998 .

[7]  Z. Berler,et al.  Effective methods of assessment of insulation system conditions in power transformers: a view based on practical experience , 1999, Proceedings: Electrical Insulation Conference and Electrical Manufacturing and Coil Winding Conference (Cat. No.99CH37035).

[8]  E. Kuffel,et al.  High voltage engineering , 2006, 2006 Eleventh International Middle East Power Systems Conference.

[9]  Monochannel propagation mechanism in transformer oil at low breakdown probabilities , 1996, ICDL'96. 12th International Conference on Conduction and Breakdown in Dielectric Liquids.

[10]  T.A. Prevost,et al.  Dielectric Properties of Natural Esters and their Influence on Transformer Insulation System Design and Performance , 2006, 2005/2006 IEEE/PES Transmission and Distribution Conference and Exhibition.

[11]  Z.D. Wang,et al.  Particle Effect on Breakdown Voltage of Mineral and Ester Based Transformer Oils , 2008, 2008 Annual Report Conference on Electrical Insulation and Dielectric Phenomena.

[12]  Mark P. Wilson.  Impulse breakdown of liquid-solid interfaces , 2011 .

[13]  E. Cherney,et al.  Electrical Breakdown at Solid-Liquid Interfaces , 1977, IEEE Transactions on Electrical Insulation.

[14]  T. Leibfried,et al.  Profile of water content and degree of polymerisation in the solid insulation of power transformers , 2004, Conference Record of the 2004 IEEE International Symposium on Electrical Insulation.

[15]  L. Lundgaard,et al.  Solubility of carboxylic acids in paper (Kraft)-oil insulation systems , 2004, The 17th Annual Meeting of the IEEE Lasers and Electro-Optics Society, 2004. LEOS 2004..

[16]  M. Harada,et al.  Ionization energies for solvated polycyclic aromatic hydrocarbons , 1999 .

[17]  O. Lesaint,et al.  On the gaseous nature of positive filamentary streamers in hydrocarbon liquids. II: Propagation, growth and collapse of gaseous filaments in pentane , 1994 .

[18]  W. Marsden.  I and J , 2012 .

[19]  Junhao Li,et al.  Partial discharge characteristics over differently aged oil/pressboard interfaces , 2009, IEEE Transactions on Dielectrics and Electrical Insulation.

[20]  I. Fofana,et al.  Water in Oil-Filled, High-Voltage Equipment, Part I: States, Solubility, and Equilibrium in Insulating Materials , 2007, IEEE Electrical Insulation Magazine.

[21]  J. H. Mason.  Breakdown of Solid Dielectrics in Divergent Fields , 1955 .

[22]  Olivier Lesaint,et al.  On the gaseous nature of positive filamentary streamers in hydrocarbon liquids. I: Influence of the hydrostatic pressure on the propagation , 1994 .

[23]  J. G. Anderson,et al.  Propagation mechanism of impulse corona and breakdown in oil , 1953, Transactions of the American Institute of Electrical Engineers, Part I: Communication and Electronics.