Heat Transfer and Flow on the First Stage Blade Tip of a Power Generation Gas Turbine: Part 2 — Simulation Results

A combined experimental and computational study has been performed to investigate the detailed distribution of convective heat transfer coefficients on the first stage blade tip surface for a geometry typical of large power generation turbines (>100MW). This paper is concerned with the numerical prediction of the tip surface heat transfer. Good comparison with the experimental measured distribution was achieved through accurate modeling of the most important features of the blade passage and heating arrangement as well as the details of experimental rig likely to affect the tip heat transfer. A sharp edge and a radiused edge tip was considered. The results using the radiused edge tip agreed better with the experimental data. This improved agreement was attributed to the absence of edge separation on the tip of the radiused edge blade.Copyright © 1999 by ASME

[1]  D. Wilcox Simulation of Transition with a Two-Equation Turbulence Model , 1994 .

[2]  Ali Ameri,et al.  Effects of Tip Clearance and Casing Recess on Heat Transfer and Stage Efficiency in Axial Turbines , 1998 .

[3]  Michael G. Dunn,et al.  Measurement and Analyses of Heat Flux Data in a Turbine Stage: Part II—Discussion of Results and Comparison With Predictions , 1984 .

[4]  D. Wilcox Turbulence modeling for CFD , 1993 .

[5]  Ali Ameri,et al.  Effect of Squealer Tip on Rotor Heat Transfer and Efficiency , 1997 .

[6]  D. Rigby,et al.  Heat transfer on a film-cooled blade – effect of hole physics , 1998 .

[7]  Ali Ameri,et al.  Internal Passage Heat Transfer Prediction Using Multiblock Grids and a k-ω Turbulence Model , 1996 .

[8]  F. Menter ZONAL TWO EQUATION k-w TURBULENCE MODELS FOR AERODYNAMIC FLOWS , 1993 .

[9]  Minking K. Chyu,et al.  Cavity Heat Transfer on a Transverse Grooved Wall in a Narrow Flow Channel , 1989 .

[10]  David L. Rigby,et al.  Numerical Prediction of Heat Transfer in a Channel With Ribs and Bleed , 1997 .

[11]  A. A. Ameri,et al.  Prediction of Unshrouded Rotor Blade Tip Heat Transfer , 1995 .

[12]  Meng-Sing Liou,et al.  Development of an explicit multiblock/multigrid flow solver for viscous flows in complex geometries , 1993 .

[13]  Meng-Sing Liou,et al.  Multigrid calculation of three-dimensional viscous cascade flows , 1991 .

[14]  A. A. Ameri,et al.  Analysis of Gas Turbine Rotor Blade Tip and Shroud Heat Transfer , 1996 .