An example of fault site localization on a 0.18 mum CMOS device with combination of front and backside techniques

Abstract This paper describes a failure analysis on a 0.18 μm CMOS device. To find out fault mechanism, combination of several fault localization techniques that are both front and backside were utilized. Fault mechanism is discussed, including the relation between the results of these techniques and physical layout with circuit information. In this case, the failure device had these features: multi-metallization process with dummy fill metals, low supply voltage, and non-function with high IDD leakage. These features made verifying the fault mechanism very difficult. We provide an approach of voltage contrast method with FIB milling techniques. This approach enabled to probe inner nodes in the multi-metallization device and to verify the fault mechanism. We also discuss the verification with circuit simulation and the root cause in detail.

[1]  P. Fazekas,et al.  Electron-beam testing of VLSI circuits , 1979, IEEE Transactions on Electron Devices.

[2]  M.J. Riezenman,et al.  Test and measurement , 1994, IEEE Spectrum.

[3]  N. Khurana,et al.  Analysis of Product Hot Electron Problems by Gated Emission Microscopy , 1986, 24th International Reliability Physics Symposium.

[4]  Thomas W. Lee,et al.  Microelectronic failure analysis : desk reference , 1993 .

[5]  D. T. Hurley,et al.  Dynamics of backside wafer level microprobing , 1998, 1998 IEEE International Reliability Physics Symposium Proceedings. 36th Annual (Cat. No.98CH36173).

[6]  Kiyoshi Nikawa,et al.  LSI failure analysis using focused laser beam heating , 1997 .

[7]  J. Soden,et al.  The use of light emission in failure analysis of CMOS ICs , 1990 .

[8]  H. Komoda,et al.  Optical Beam Induced Current Techniques for Failure Analysis of Very Large Scale Integrated Circuits Devices , 1994 .

[9]  Silke Liebert,et al.  Failure analysis from the back side of a die , 2001, Proceedings of the 2001 8th International Symposium on the Physical and Failure Analysis of Integrated Circuits. IPFA 2001 (Cat. No.01TH8548).