Parametric Thermodynamic Analysis of a Solid Oxide Fuel Cell Gas Turbine System Design Space

A parametric study of a solid oxide fuel cell-gas turbine (SOFC-GT) hybrid system design is conducted with the intention of determining the thermodynamically based design space constrained by modern material and operating limits. The analysis is performed using a thermodynamic model of a generalized SOFC-GT system where the sizing of all components, except the fuel cell, is allowed to vary. Effects of parameters such as pressure ratio, fuel utilization, oxygen utilization, and current density are examined. Operational limits are discussed in terms of maximum combustor exit temperature, maximum heat exchanger effectiveness, limiting current density, maximum hydrogen utilization, and fuel cell temperature rise. It was found that the maximum hydrogen utilization and combustor exit temperature were the most significant constraints on the system design space. The design space includes the use of cathode flow recycling and air preheating via a recuperator (heat exchanger). The effect on system efficiency of exhaust gas recirculation using an ejector versus using a blower is discussed, while both are compared with the base case of using a heat exchanger only. It was found that use of an ejector for exhaust gas recirculation caused the highest efficiency loss, and the base case was found to exhibit the highest overall system efficiency. The use of a cathode recycle blower allowed the largest downsizing of the heat exchanger, although avoiding cathode recycling altogether achieved the highest efficiency. Efficiencies in the range of 50-75% were found for variations in pressure ratio, fuel utilization, oxygen utilization, and current density. The best performing systems that fell within all design constraints were those that used a heat exchanger only to preheat air, moderate pressure ratios, low oxygen utilizations, and high fuel utilizations. Copyright © 2010 by ASME.

[1]  Rory A. Roberts,et al.  Control Design for a Bottoming Solid Oxide Fuel Cell Gas Turbine Hybrid System , 2006 .

[2]  Nigel P. Brandon,et al.  Anode-supported intermediate-temperature direct internal reforming solid oxide fuel cell. II. Model-based dynamic performance and control , 2005 .

[3]  Francesco Calise,et al.  Simulation and exergy analysis of a hybrid Solid Oxide Fuel Cell (SOFC)–Gas Turbine System , 2006 .

[4]  Pedro Nehter,et al.  A high fuel utilizing solid oxide fuel cell cycle with regard to the formation of nickel oxide and power density , 2007 .

[5]  F. Calise,et al.  Design and partial load exergy analysis of hybrid SOFC–GT power plant , 2006 .

[6]  Christopher J. Koroneos,et al.  Advantages of the use of hydrogen fuel as compared to kerosene , 2005 .

[7]  Changyun Wen,et al.  Fuel ejector design and simulation model for anodic recirculation SOFC system , 2007 .

[8]  Francesco Calise,et al.  Full load synthesis/design optimization of a hybrid SOFC–GT power plant , 2007 .

[9]  Paul C. Schmitz,et al.  Fuel Cell Propulsion Systems for an All-electric Personal Air Vehicle , 2003 .

[10]  W. Winkler,et al.  The design of stationary and mobile solid oxide fuel cell–gas turbine systems , 2002 .

[11]  Fabian Mueller,et al.  Synergistic integration of a gas turbine and solid oxide fuel cell for improved transient capability , 2008 .

[12]  Tong Seop Kim,et al.  Design performance analysis of pressurized solid oxide fuel cell/gas turbine hybrid systems considering temperature constraints , 2006 .

[13]  I. Celik,et al.  A numerical study of cell-to-cell variations in a SOFC stack , 2004 .

[14]  Kyeongmin Oh,et al.  Analysis of the design of a pressurized SOFC hybrid system using a fixed gas turbine design , 2007 .

[15]  Jarosław Milewski,et al.  Off-design analysis of SOFC hybrid system , 2007 .

[16]  Zhenping Feng,et al.  Dynamic modeling of a hybrid system of the solid oxide fuel cell and recuperative gas turbine , 2006 .

[17]  Chellappa Balan,et al.  Coal Integrated Gasification Fuel Cell System Study , 2003 .

[18]  Aristide F. Massardo,et al.  Design and Testing of Ejectors for High Temperature Fuel Cell Hybrid Systems , 2006 .

[19]  Lars Imsland,et al.  Control strategy for a solid oxide fuel cell and gas turbine hybrid system , 2006 .

[20]  N. Sammes,et al.  Dynamic modeling of single tubular SOFC combining heat/mass transfer and electrochemical reaction effects , 2005 .

[21]  S. Chan,et al.  Energy and exergy analysis of simple solid-oxide fuel-cell power systems , 2002 .

[22]  S. Campanari,et al.  Definition and sensitivity analysis of a finite volume SOFC model for a tubular cell geometry , 2004 .

[24]  Bjarne A. Foss,et al.  Modeling and control of a SOFC-GT-based autonomous power system , 2007 .

[25]  J. P. Strakey,et al.  U.S. DOE fossil energy fuel cells program , 2006 .

[26]  Atsushi Tsutsumi,et al.  Energy recuperation in solid oxide fuel cell (SOFC) and gas turbine (GT) combined system , 2003 .

[27]  Anthony J. Colozza,et al.  Hydrogen Storage for Aircraft Applications Overview , 2002 .

[28]  S. Singhal,et al.  Polarization Effects in Intermediate Temperature, Anode‐Supported Solid Oxide Fuel Cells , 1999 .

[29]  Tong Seop Kim,et al.  Comparison between pressurized design and ambient pressure design of hybrid solid oxide fuel cell–gas turbine systems , 2006 .

[30]  Srikanth Gopalan,et al.  Polarization measurements on single-step co-fired solid oxide fuel cells (SOFCs) , 2007 .

[31]  H. Ho,et al.  Modelling of simple hybrid solid oxide fuel cell and gas turbine power plant , 2002 .

[32]  Ashok Rao,et al.  Sensitivity analysis of a Vision 21 coal based zero emission power plant , 2006 .

[33]  Loredana Magistri,et al.  Ejector performance influence on a solid oxide fuel cell anodic recirculation system , 2004 .

[34]  David L. Daggett,et al.  Fuel Cell APU , 2003 .

[35]  Fabian Mueller,et al.  Dynamic Simulation of an Integrated Solid Oxide Fuel Cell System Including Current-Based Fuel Flow Control , 2005 .

[36]  Pierluigi Leone,et al.  Experimental evaluation of the sensitivity to fuel utilization and air management on a 100 kW SOFC system , 2007 .

[37]  Jun Li,et al.  Cycle analysis of an integrated solid oxide fuel cell and recuperative gas turbine with an air reheating system , 2007 .

[38]  Olav Bolland,et al.  Finite-volume modeling and hybrid-cycle performance of planar and tubular solid oxide fuel cells , 2005 .

[39]  H. Ho,et al.  Multi-level modeling of SOFC–gas turbine hybrid system , 2003 .

[40]  Francesco Calise,et al.  Single-level optimization of a hybrid SOFC-GT power plant , 2006 .

[41]  Erian A. Baskharone.  Principles of turbomachinery in air-breathing engines , 2006 .

[42]  G. S. Samuelsen,et al.  A thermodynamic analysis of tubular solid oxide fuel cell based hybrid systems , 2003 .