Mathematical modelling of sewage sludge incineration in a bubbling fluidised bed with special consideration for thermally-thick fuel particles.

Fluidised bed combustor (FBC) is one of the key technologies for sewage sludge incineration. In this paper, a mathematical model is developed for the simulation of a large-scale sewage sludge incineration plant. The model assumes the bed consisting of a fast-gas phase, an emulsion phase and a fuel particle phase with specific consideration for thermally-thick fuel particles. The model further improves over previous works by taking into account throughflow inside the bubbles as well as the floating and random movement of the fuel particles inside the bed. Validation against both previous lab-scale experiments and operational data of a large-scale industrial plant was made. Calculation results indicate that combustion split between the bed and the freeboard can range from 60/40 to 90/10 depending on the fuel particle distribution across the bed height under the specific conditions. The bed performance is heavily affected by the variation in sludge moisture level. The response time to variation in feeding rate is different for different parameters, from 6 min for outlet H2O, 10 min for O2, to 34 min for bed temperature.

[1]  Paolo Bolzern,et al.  A model of a bubbling fluidized bed combustor oriented to char mass estimation , 2000, IEEE Transactions on Control Systems Technology.

[2]  Vida N. Sharifi,et al.  Numerical Simulation of the Burning Characteristics of Thermally-Thick Biomass Fuels in Packed-Beds , 2005 .

[3]  D. L. Pyle,et al.  Heat transfer and kinetics in the low temperature pyrolysis of solids , 1984 .

[4]  H. Hofbauer,et al.  Study on NO and N2O Formation and Destruction Mechanisms in a Laboratory-Scale Fluidized Bed , 2002 .

[5]  G. Baldi,et al.  Modelling of catalytic gas–solid fluidised bed reactors , 1999 .

[6]  C. Y. Wen,et al.  A comprehensive model for fluidized bed coal combustors , 1980 .

[7]  John Nijenhuis,et al.  Early Agglomeration Recognition System (EARS) , 2003 .

[8]  Dongke Zhang,et al.  A non-isothermal model of a bubbling fluidised-bed coal gasifier , 2005 .

[9]  D. Cassel,et al.  Physical Properties of Three Sand Size Classes Amended with Inorganic Materials or Sphagnum Peat Moss for Putting Green Rootzones , 2004 .

[10]  Derek Geldart,et al.  Homogeneous fluidization of fine powders using various gases and pressures , 1978 .

[11]  J. S. Dennis,et al.  The devolatilisation of particles of a complex fuel (dried sewage sludge) in a fluidised bed , 2007 .

[12]  Gennadij I. Palconok.  Heat and Mass Transfer to a Single Particle in Fluidized Bed , 1998 .

[13]  Nevin Selçuk,et al.  Modeling of a Bubbling AFBC with Volatiles Release , 2003 .

[14]  J. Grace,et al.  The behaviour of freely bubbling fluidised beds , 1969 .

[15]  Peter Harriott,et al.  Unit Operations of Chemical Engineering , 2004 .

[16]  Changkook Ryu,et al.  Effect of Model and Operating Parameters on Air Gasification of Char , 2006 .

[17]  C. Y. Wen,et al.  Estimation of bubble diameter in gaseous fluidized beds , 1975 .

[18]  Fabrizio Scala,et al.  Modelling fluidized bed combustion of high-volatile solid fuels , 2002 .

[19]  Y. R. Goh,et al.  Mathematical modelling of MSW incineration on a travelling bed. , 2002, Waste management.

[20]  D. Geldart.  Types of gas fluidization , 1973 .

[21]  S. Ergun.  Fluid flow through packed columns , 1952 .

[22]  K. Kato,et al.  Bubble assemblage model for fluidized bed catalytic reactors , 1969 .

[23]  K. Choi,et al.  Modeling of particle segregation phenomena in a gas phase fluidized bed olefin polymerization reactor , 2001 .

[24]  J. Vaxelaire,et al.  Use of a transient model to simulate fluidized bed incineration of sewage sludge. , 2006, Journal of hazardous materials.

[25]  J. Werther,et al.  Combustion of coffee husks , 2001 .

[26]  J. Swithenbank,et al.  Effects of fuel devolatilisation on the combustion of wood chips and incineration of simulated municipal solid wastes in a packed bed , 2003 .

[27]  M. D. Souza-Santos.  Comprehensive modelling and simulation of fluidized bed boilers and gasifiers , 1989 .

[28]  Joachim Werther,et al.  Combustion characteristics of wet sludge in a fluidized bed: Release and combustion of the volatiles , 1996 .

[29]  Kevin Whitty,et al.  Investigation of Fuel Chemistry and Bed Performance in a Fluidized Bed Black Liquor Steam Reformer , 2003 .

[30]  J. Werther,et al.  Sewage sludge combustion , 1999 .

[31]  Ian C. Kemp,et al.  Mathematical modelling of fluidised bed dryers with horizontal dispersion , 1999 .