论文信息 - Research on WEDM Process Optimization for PCD Micro Milling Tool

Research on WEDM Process Optimization for PCD Micro Milling Tool

Abstract An initial study on WEDM process optimization for PCD micro milling tool has been carried out. With a orthogonal design of roughing and finishing condition experiment of PCD, a largest difference of WEDM parameter is obtained to calculate the influence of those parameter on cutting speed for roughing operation and surface roughness Ra and metamorphic layer thickness for finishing operation. For roughing operation, peak current and voltage pulse width are the dominant WEDM parameters; while for finishing operation, Peak current, peak voltage are the largest influence of parameters on cutting speed. With WEDM optimized parameters, a quadrilateral PCD micro milling tool is fabricated with CTB002 PCD material. Tool edge radius is 6.7 m.

[1] R. Ryan Vallance,et al. Micro-machining and micro-grinding with tools fabricated by micro electro-discharge machining , 2006 .

[2] Simon S. Park,et al. Investigation of micro-cutting operations , 2006 .

[3] Kazuo Yamazaki,et al. Design and development of PCD micro straight edge end mills for micro/nano machining of hard and brittle materials , 2010 .

[4] G. L. Benavides,et al. Micromilling of metal alloys with focused ion beam–fabricated tools , 1999 .

[5] Eric R. Marsh,et al. Micro machining glass with polycrystalline diamond tools shaped by micro electro discharge machining , 2004 .

[6] Jürgen Fleischer,et al. Design and manufacturing of micro milling tools , 2008 .

[7] Tsunemoto Kuriyagawa,et al. Fabrication of micro end mills by wire EDM and some micro cutting tests , 2009 .

[8] Eckart Uhlmann,et al. Dynamic Load and Strain Analysis for the Optimization of Micro End Mills , 2005 .

[9] Jan C. Aurich,et al. Manufacture and application of ultra-small micro end mills , 2012 .