Biomechanical Evaluation of Vertebroplasty and Kyphoplasty With Polymethyl Methacrylate or Calcium Phosphate Cement Under Cyclic Loading

Study Design. We developed a new method to simulating in vivo dynamic loading as closely as possible, which allows comparison of kyphoplasty and vertebroplasty, as well as augmentation materials. Objective. Special interest was given to calcium phosphate cement, which might fail due to its brittleness. Summary of Background Data. Vertebroplasty and kyphoplasty are, with limitations, 2 promising alternative techniques to augment osteoporotic vertebrae with polymethyl methacrylate or calcium phosphate cements. However, little is known about the fatigue characteristics of the treated vertebrae under cyclic loading. Methods. Twenty-four intact, osteoporotic bi-segmental human specimens were divided into 4 groups: (1) vertebroplasty with polymethyl methacrylate, (2) kyphoplasty with polymethyl methacrylate, (3) kyphoplasty with calcium phosphate cement, and (4) untreated control group. After augmentation of the middle vertebrae, all specimens underwent 100,000 cycles of eccentric loading during which the specimen revolved around its longitudinal axis. Pre-loading and post-loading radiographs, and subsidence measurements at different sites of the vertebrae were taken. The overall height was additionally determined every 20,000 cycles in the material testing machine. Finally, the specimens were cryosectioned to examine the cements. Results. Loss of height progressed with strong individual differences in all groups, with an increasing number of load cycles up to median values of 2.8 mm for both augmented groups and 4.2 mm for the nonaugmented group. At the center of the upper endplate, subsidence in kyphoplasty was greater than in vertebroplasty, with little differences with respect to the kind of cement. The cryosections did not show any signs of fatigue in the polymethyl methacrylate, but small cracks were in the calcium phosphate. Conclusions. Vertebroplasty and kyphoplasty seem to be equivalent methods in strengthening osteoporotic vertebrae. However, these results cannot be transferred to the treatment of fractures with these methods. A “physiologic” loading situation was achieved by complex motion, including all combinations of flexion/extension with lateral bending during eccentric cyclic loading.

[1]  Mark A. Reiley,et al.  New Technologies in Spine: Kyphoplasty and Vertebroplasty for the Treatment of Painful Osteoporotic Compression Fractures , 2001, Spine.

[2]  Mark A. Reiley,et al.  1999 Young Investigator Research Award Runner-Up: Effect of Augmentation on the Mechanics of Vertebral Wedge Fractures , 2000, Spine.

[3]  P. Heini,et al.  Percutaneous transpedicular vertebroplasty with PMMA: operative technique and early results , 2000, European Spine Journal.

[4]  S. Belkoff,et al.  The Biomechanics of Vertebroplasty: The Effect of Cement Volume on Mechanical Behavior , 2001, Spine.

[5]  Gunnar B. J. Andersson,et al.  Biomechanical Evaluation of an Injectable Calcium Phosphate Cement for Vertebroplasty , 2002, Spine.

[6]  L. Nolte,et al.  The Effect of Cement Augmentation on the Load Transfer in an Osteoporotic Functional Spinal Unit: Finite-Element Analysis , 2003, Spine.

[7]  S. Cummings,et al.  Comparison of semiquantitative visual and quantitative morphometric assessment of prevalent and incident vertebral fractures in osteoporosis , 1996 .

[8]  Stephen J. Ferguson,et al.  Adjacent vertebral failure after vertebroplasty , 2002 .

[9]  J. Torner,et al.  Comparison of the biomechanics of hydroxyapatite and polymethylmethacrylate vertebroplasty in a cadaveric spinal compression fracture model. , 2001, Journal of neurosurgery.

[10]  Christoph Fankhauser,et al.  Augmentation of mechanical properties in osteoporotic vertebral bones – a biomechanical investigation of vertebroplasty efficacy with different bone cements , 2001, European Spine Journal.

[11]  S. Belkoff,et al.  An Ex Vivo Biomechanical Evaluation of an Inflatable Bone Tamp Used in the Treatment of Compression Fracture , 2001, Spine.

[12]  I. Lieberman,et al.  Initial Outcome and Efficacy of “Kyphoplasty” in the Treatment of Painful Osteoporotic Vertebral Compression Fractures , 2001, Spine.

[13]  B Delcambre,et al.  Percutaneous vertebroplasty in the treatment of osteoporotic vertebral compression fractures: an open prospective study. , 1999, The Journal of rheumatology.

[14]  W. Lu,et al.  Bioactive Bone Cement as a Principal Fixture for Spinal Burst Fracture: An In Vitro Biomechanical and Morphologic Study , 2001, Spine.

[15]  J. Barr,et al.  Percutaneous Vertebroplasty for Pain Relief and Spinal Stabilization , 2000, Spine.

[16]  P. Heini,et al.  Bone substitutes in vertebroplasty , 2001, European Spine Journal.

[17]  T. Markwalder,et al.  Re: Percutaneous vertebroplasty for pain relief and spinal stabilization (Spine 2000; 25: 923-8). , 2000, Spine.

[18]  S. Belkoff,et al.  Ex vivo biomechanical comparison of hydroxyapatite and polymethylmethacrylate cements for use with vertebroplasty. , 2002, AJNR. American journal of neuroradiology.

[19]  Alf Nachemson,et al.  In Vivo Measurements of Intradiscal Pressure , 1964 .

[20]  D A Rüfenacht,et al.  Vertebroplasty: clinical experience and follow-up results. , 1999, Bone.

[21]  M. Bohner.  Physical and chemical aspects of calcium phosphates used in spinal surgery , 2001, European Spine Journal.

[22]  S. Belkoff,et al.  Temperature elevation caused by bone cement polymerization during vertebroplasty. , 1999, Bone.

[23]  L. Claes,et al.  Effect of a prosthetic disc nucleus on the mobility and disc height of the L4-5 intervertebral disc postnucleotomy. , 2001, Journal of neurosurgery.

[24]  L. Claes,et al.  New in vivo measurements of pressures in the intervertebral disc in daily life. , 1999, Spine.

[25]  L. Nolte,et al.  Adjacent vertebral failure after vertebroplasty. A biomechanical investigation. , 2002, The Journal of bone and joint surgery. British volume.

[26]  B. Bai,et al.  The use of an injectable, biodegradable calcium phosphate bone substitute for the prophylactic augmentation of osteoporotic vertebrae and the management of vertebral compression fractures. , 1999, Spine.