Preventive Thermographic Diagnostic of a HV

For the purpose of increasing quality, continuity and, at the same time, of increasing reliability and decreasing the losses in an electric power system (EPS), there is an emerging need for preventive diagnostic testing. From the standpoint of an electric power system availability, it is desirable to perform as many tests as possible without a violation of operating conditions of the system itself. The paper presents the thermographic testing of a HV disconnector, as an online testing with the aim of preventive maintenance and condition diagnosis of particular elements, as well as the suggestions for taking adequate measures with the aim of removing potential malfunctions. For the testing results to be quality and to give a reliable information, the load of a facility must be bigger that 50% of the nominal power. On the basis of obtained thermograms, the analysis of the disconnector and its contacts is performed, as well as of the contacts towards other elements in the facility.

[1]  Miss A.O. Penney.  (b) , 1974, The New Yale Book of Quotations.

[2]  J. Bezdek,et al.  FCM: The fuzzy c-means clustering algorithm , 1984 .

[3]  Paul Geladi,et al.  Principal Component Analysis , 1987, Comprehensive Chemometrics.

[4]  Z. Wang,et al.  2-MOSFET transresistor with extremely low distortion for output reaching supply voltages , 1990 .

[5]  Maria A. Stuchly,et al.  Pacemaker interference by 60-Hz contact currents , 2002, IEEE Transactions on Biomedical Engineering.

[6]  Jan W. M. Bergmans,et al.  An Improved Adaptive Power Line Interference Canceller for Electrocardiography , 2006, IEEE Transactions on Biomedical Engineering.

[7]  Moon-Que Lee,et al.  A Passive Circulator with High Isolation using a Directional Coupler for RFID , 2006, 2006 IEEE MTT-S International Microwave Symposium Digest.

[8]  Hong-Gu Cho,et al.  Directional coupler for UHF mobile RFID reader , 2007 .

[9]  Y. Maday,et al.  Optimal convergence properties of the FETI domain decomposition method , 2007 .

[10]  Lingling Sun,et al.  Radio link analysis and design of directional coupler with high isolation for UHF RFID reader , 2008, 2008 11th IEEE International Conference on Communication Technology.

[11]  Sudhanshu Maheshwari,et al.  Voltage Mode Cascadable AllPass Sections Using Single Active Element and Grounded Passive Components , 2010, Circuits Syst..

[12]  Cristina Turcu.  Radio Frequency Identification Fundamentals and Applications Design Methods and Solutions , 2010 .

[13]  Hakan Kuntman,et al.  New Simple CMOS Realization of Voltage Differencing Transconductance Amplifier and Its RF Filter Application , 2011 .

[14]  Sudhanshu Maheshwari,et al.  Mixed-mode quadrature oscillator using translinear conveyors and grounded capacitors , 2011, 2011 International Conference on Multimedia, Signal Processing and Communication Technologies.

[15]  K. Xie,et al.  Directional coupler design based on coupled cavity waveguides in photonic crystals , 2011 .

[16]  P. C. Bhaskar,et al.  REDUCTION OF POWER LINE INTERFERENCE IN ECG SIGNAL USING FIR FILTER , 2012 .

[17]  Sudhanshu Maheshwari,et al.  Second Order Mixed Mode Quadrature Oscillator using DVCCs and Grounded Components , 2012 .

[18]  Sudhanshu Maheshwari,et al.  High-input low-output impedance all-pass filters using one active element , 2012, IET Circuits Devices Syst..

[19]  Di Zhao,et al.  A Simulation and Prediction Method of the Height of Wheat Based on BP Neural Networks and the Ant Colony Algorithm , 2013 .

[20]  Ahmed M. Soliman,et al.  Two integrator loop quadrature oscillators: A review , 2012, Journal of advanced research.

[21]  Di Zhao,et al.  An Improved ICA Algorithm Based on the Negative Entropy and Simulated Annealing Algorithm , 2013 .

[22]  SudhanshuMaheshwari.  Voltage-Mode Four-Phase Sinusoidal Generator and Its Useful Extensions , 2015 .