Fabrication and testing of phase change heat sink for high power LED

[1]  Wei Zhou,et al.  A novel miniaturized loop heat pipe , 2010 .

[2]  Wei Zhou,et al.  Forming technology of boiling structure on evaporation surface of phase-change heat sink for high-power light emitting diode , 2010 .

[3]  Yong Tang,et al.  A performance study of methanol steam reforming microreactor with porous copper fiber sintered felt as catalyst support for fuel cells , 2009 .

[4]  T. Hua,et al.  Thermal analysis of loop heat pipe used for high-power LED , 2009 .

[5]  Wei Zhou,et al.  Compound forming technology of outside 3D integral fin of copper tubes , 2009 .

[6]  Chun-Jen Weng,et al.  Advanced thermal enhancement and management of LED packages , 2009 .

[7]  Samuel Graham,et al.  Thermal effects in packaging high power light emitting diode arrays , 2009 .

[8]  周伟,et al.  Compound forming technology of outside 3D integral fin of copper tubes , 2009 .

[9]  Xiaobing Luo,et al.  Structural optimization of a microjet based cooling system for high power LEDs , 2008 .

[10]  Yong Tang,et al.  A novel finned micro-groove array structure and forming process , 2008 .

[11]  L. L. Vasiliev,et al.  Micro and miniature heat pipes – Electronic component coolers , 2008 .

[12]  Y. Ahmed,et al.  Correlation between factors controlling preparation of porous copper via sintering technique using experimental design , 2007 .

[13]  Jong Hwa Choi,et al.  Thermal analysis of LED array system with heat pipe , 2007 .

[14]  R. Jaeger,et al.  Effect of nucleation site spacing on the pool boiling characteristics of a structured surface , 2006 .

[15]  N. Narendran,et al.  Life of LED-based white light sources , 2005, Journal of Display Technology.

[16]  Jean Paul Freyssinier,et al.  Solid-state lighting: failure analysis of white LEDs , 2004 .

[17]  Paul S. Martin,et al.  Illumination with solid state lighting technology , 2002 .

[18]  S. A. Stockman,et al.  Performance of high-power AlInGaN light emitting diodes , 2001 .

[19]  Yong,et al.  Fin formation model during pre-roll ploughing of copper 3D outside fin tube , 2001 .