Experimental study on load dependent X-parameter models for PA design

The X-parameter model is designed for modeling weakly nonlinear devices in an approximately impedance-matched environment. Load dependent X-parameter models were proposed to overcome this, practically very relevant, limitation and model a nonlinear device in a highly mismatched environment. However, the applicability of load dependent X-parameter models for DUTs operating in deep saturation like in power amplifier design is questionable. This work evaluates the possibilities of using a load dependent X-parameter model in power amplifier design by comparing the results of a model build from measurements of a GaN-HEMT to in-situ measurements of the same device.

[1]  Fadhel M. Ghannouchi,et al.  Load-Pull Techniques with Applications to Power Amplifier Design , 2012 .

[2]  D.E. Root,et al.  Load-pull + NVNA = enhanced X-parameters for PA designs with high mismatch and technology-independent large-signal device models , 2008, 2008 72nd ARFTG Microwave Measurement Symposium.

[3]  D.E. Root,et al.  Polyharmonic distortion modeling , 2006, IEEE Microwave Magazine.

[4]  Jianjun Xu,et al.  Multi-tone, Multi-port, and Dynamic Memory Enhancements to PHD Nonlinear Behavioral Models from Large-signal Measurements and Simulations , 2007, 2007 IEEE/MTT-S International Microwave Symposium.

[5]  Gottfried Magerl,et al.  On the dependability of load dependent X-parameter models for varying loads , 2017, 2017 Integrated Nonlinear Microwave and Millimetre-wave Circuits Workshop (INMMiC).

[6]  Dominique Schreurs,et al.  Systematic procedure for load-pull X-parameters measurements for high-efficiency GaN HEMT PA design , 2014, 2014 20th International Conference on Microwaves, Radar and Wireless Communications (MIKON).