Describes a series of experiments in the Joint European Torus (JET), culminating in the first tokamak discharges in deuterium-tritium fuelled mixture. The experiments were undertaken within limits imposed by restrictions on vessel activation and tritium usage. The objectives were: (i) to produce more than one megawatt of fusion power in a controlled way; (ii) to validate transport codes and provide a basis for accurately predicting the performance of deuterium-tritium plasmas from measurements made in deuterium plasmas; (iii) to determine tritium retention in the torus systems and to establish the effectiveness of discharge cleaning techniques for tritium removal; (iv) to demonstrate the technology related to tritium usage; and (v) to establish safe procedures for handling tritium in compliance with the regulatory requirements. A single-null X-point magnetic configuration, diverted onto the upper carbon target, with reversed toroidal magnetic field was chosen. Deuterium plasmas were heated by high power, long duration deuterium neutral beams from fourteen sources and fuelled also by up to two neutral beam sources injecting tritium. The results from three of these high performance hot ion H-mode discharges are described: a high performance pure deuterium discharge; a deuterium-tritium discharge with a 1% mixture of tritium fed to one neutral beam source; and a deuterium-tritium discharge with 100% tritium fed to two neutral beam sources. The TRANSP code was used to check the internal consistency of the measured data and to determine the origin of the measured neutron fluxes. In the best deuterium-tritium discharge, the tritium concentration was about 11% at the time of peak performance, when the total neutron emission rate was 6.0 × 1017 neutrons/s. The integrated total neutron yield over the high power phase, which lasted about 2 s, was 7.2 × 1017 neutrons, with an accuracy of ±7%. The actual fusion amplification factor, QDT was about 0.15
[1]
Tadashi Sekiguchi,et al.
Plasma Physics and Controlled Nuclear Fusion Research
,
1987
.
[2]
F. Wagner,et al.
Regime of Improved Confinement and High Beta in Neutral-Beam-Heated Divertor Discharges of the ASDEX Tokamak
,
1982
.
[3]
J. Ehrenberg.
Modelling of isotope exchange experiments in JET
,
1987
.
[4]
Technical Information,et al.
The JET Project (design proposal)
,
1976
.
[5]
A. Gibson.
Fusion relevant performance in JET
,
1990
.
[6]
Barnes,et al.
The absolute calibration of gauges for tritium gas in the pressure range 10−8 to 10−5 torr
,
1968
.
[7]
J. Cordey,et al.
Extrapolation of the high-performance JET plasmas to D-T operation
,
1991
.
[8]
D. McCune,et al.
New techniques for calculating heat and particle source rates due to neutral beam injection in axisymmetric tokamaks
,
1981
.