Fretting Wear Simulation of Press-Fitted Shaft with Finite Element Analysis and Influence Function Method

[1]  S. Hillmansen,et al.  A brief historical overview of the fatigue of railway axles , 2004 .

[2]  C Lonsdale,et al.  North American axle failure experience , 2004 .

[3]  I. R. McColl,et al.  Finite element simulation and experimental validation of fretting wear , 2004 .

[4]  Sean B. Leen,et al.  The effect of slip regime on fretting wear-induced stress evolution , 2004 .

[5]  L. J. Yang.  Wear coefficient equation for aluminium-based matrix composites against steel disc , 2003 .

[6]  Y. Kondo,et al.  Effect of understress on fretting fatigue crack initiation of press-fitted axle , 2003 .

[7]  Mona Öqvist,et al.  Numerical simulations of mild wear using updated geometry with different step size approaches , 2001 .

[8]  D. Hills,et al.  Partial slip between contacting cylinders under transverse and axial shear , 2000 .

[9]  Sören Andersson,et al.  Simulating sliding wear with finite element method , 1999 .

[10]  Kenji Hirakawa,et al.  The analysis and prevention of failure in railway axles , 1998 .

[11]  L. Johansson,et al.  Numerical Simulation of Contact Pressure Evolution in Fretting , 1994 .

[12]  邦夫 西岡,et al.  軸圧入部の疲れ強さ向上に関する研究 : 第2報, 二次元光弾性実験結果 , 1970 .

[13]  J. Archard.  Contact and Rubbing of Flat Surfaces , 1953 .

[14]  Julian M. Allwood,et al.  Survey and Performance Assessment of Solution Methods for Elastic Rough Contact Problems , 2005 .

[15]  H. Komatsu,et al.  Researches on Increasing the Fatigue Strength of Press-Fitted Axle , 1967 .