Influence of temperature and humidity on adhesion of underfills for flip chip packaging

This paper systematically discusses the influence of temperature and humidity on the adhesion performance of underfill material (epoxy cured with acid anhydride), which was evaluated by die shear test after exposure to various conditions. The inherent adhesion strength between the underfill and passivation is not affected significantly by thermal cycling between -55/spl deg/C and 125/spl deg/C for 1000 cycles. The adhesion strength of underfill material decreases with the increase of test temperature in the investigated range, due to the decrease of modulus of the underfill with the increase of temperature. A sharp decrease in adhesion strength occurs as temperature increases toward the glass transition temperature of the underfill material. Adhesion strength of underfill with different passivation materials decreases after aging in a high temperature and high humidity environment. The extent of the decrease depends on underfill formulation and the hydrophilicity of the passivation material. Hydrophilic passivation such silicon oxide (SiO/sub 2/) and silicon nitride (Si/sub 3/N/sub 4/) shows much more severe adhesion degradation than hydrophobic passivation such as benzocyclobutene (BCB) and polyimide (PI). Adhesion degradation is slower than moisture diffusion. The adhesion stability for hydrophilic passivation can be successfully improved by use of a coupling agent such as silane that introduces stable chemical bonds at interface.

[1]  E. H. Andrews.  Generalized Fracture Mechanics Approach to Adhesion , 1991 .

[2]  C. Wong,et al.  Study on mobility of water and polymer chain in epoxy for microelectronic applications , 2001, 2001 Proceedings. 51st Electronic Components and Technology Conference (Cat. No.01CH37220).

[3]  Shijian Luo,et al.  Investigation on effect of coupling agents in epoxy based underfill material for flip chip application , 2000, 2000 Proceedings. 50th Electronic Components and Technology Conference (Cat. No.00CH37070).

[4]  Chemical kinetic model of interfacial degradation of adhesive joints , 1999 .

[5]  E. Kramer,et al.  Characterization of underfill/passivation interfacial adhesion for direct chip attach assemblies using fracture toughness and hydro-thermal fatigue measurements , 1998, 1998 Proceedings. 48th Electronic Components and Technology Conference (Cat. No.98CH36206).

[6]  J. V. Vroonhoven.  Effects of Adhesion and Delamination on Stress Singularities in Plastic-Packaged Integrated Circuits , 1993 .

[7]  Ranjan Rajoo,et al.  The mechanics and impact of hygroscopic swelling of polymeric materials in electronic packaging , 2000, 2000 Proceedings. 50th Electronic Components and Technology Conference (Cat. No.00CH37070).

[8]  W. T. Chen,et al.  Materials and mechanics issues in flip-chip organic packaging , 1996, 1996 Proceedings 46th Electronic Components and Technology Conference.

[9]  C.P. Wong,et al.  Preencapsulation cleaning methods and control for microelectronics packaging , 1994, 1994 Proceedings. 44th Electronic Components and Technology Conference.

[10]  Encapsulants used in flip-chip packages , 1993 .

[11]  R. A. Pearson,et al.  Fundamental study on adhesion improvement for underfill using adhesion promoter , 2001, 2001 Proceedings. 51st Electronic Components and Technology Conference (Cat. No.01CH37220).

[12]  Paul S. Ho,et al.  Polymer interfacial adhesion in microelectronic assemblies , 1998, 1998 Proceedings. 48th Electronic Components and Technology Conference (Cat. No.98CH36206).