论文信息 - An investigation of surface roughness of burnished AISI 1042 steel

An investigation of surface roughness of burnished AISI 1042 steel

The aim of this study is to analyse the evolution of surface roughness finished by burnishing. Burnishing is done on a surface that was initially turned or turned and then ground.It has been noted that burnishing an AISI 1042 steel offers the best surface quality when using a small feed value. This finishing process improves roughness and introduces compressive residual stresses in the machined surface. So, it can replace grinding in the machining range of the piece.Also, an analytical model has been defined to determine the Rt factor in relation to the feed. Good correlations have been found between the experimental and analytical results.

[1] M. S. Shunmugam,et al. Investigations into surface topography, microhardness and residual stress in Boring Trepanning Association machining , 1987 .

[2] Adel Mahmood Hassan. An investigation into the surface characteristics of burnished cast AlCu alloys , 1997 .

[3] A. Dias,et al. Residual stress analysis in orthogonal machining of standard and resulfurized AISI 316L steels , 1999 .

[4] W. Bouzid Saï,et al. Influence of finishing by burnishing on surface characteristics , 2003 .

[5] V. Hauk,et al. Residual stresses in science and technology , 1987 .

[6] M. Barash,et al. Variables Governing Patterns of Mechanical Residual Stress in a Machined Surface , 1982 .

[7] Y. Matsumoto,et al. The Effect of Hardness on Residual Stresses in Orthogonal Machining of AISI 4340 Steel , 1990 .

[8] B. Scholtes. RESIDUAL STRESSES INTRODUCED BY MACHINING , 1987 .

[9] G. M. Zhang,et al. Dynamic Generation of Machined Surfaces, Part 2: Construction of Surface Topography , 1991 .

[10] J. Lebrun,et al. Influence of machining by finishing milling on surface characteristics , 2001 .