Dynamical profile of a switched-mode converter - reality or imagination

An electrical device such as a switched-mode converter has unique internal dynamical profile, which mainly dictates, how the device as a subsystem in an interconnected system would behave and how it will affect the other subsystems within the constellation. The paper defines the vital representative parameters by means of which the stability and dynamics of the individual electrical device as well as the overall interconnected system can be analyzed and predicted. The very existence of such a dynamical priflle is proved based on extensive experimental evidence.

[1]  R. D. Middlebrook,et al.  Input filter considerations in design and application of switching regulators. , 1976 .

[2]  Teuvo Suntio,et al.  Dynamical Characterization of Input-Voltage-Feedforward-Controlled Buck Converter , 2007, IEEE Transactions on Industrial Electronics.

[3]  Slobodan Cuk,et al.  A general unified approach to modelling switching-converter power stages , 1977 .

[4]  Chi K. Tse.  Linear Circuit Analysis , 1998 .

[5]  Fred C. Lee,et al.  A method of defining the load impedance specification for a stable distributed power system , 1993 .

[6]  V. J. Thottuvelil.  Modeling and analysis of power converter systems with batteries , 1997, Proceedings of Power and Energy Systems in Converging Markets.

[7]  Teuvo Suntio,et al.  Load-imposed instability and performance degradation in a regulated converter , 2006 .

[8]  Teuvo Suntio,et al.  Load and supply invariance in a regulated converter , 2006 .

[9]  Teuvo Suntio,et al.  Unified small-signal model for PCM control in CCM: unterminated modeling approach , 2005 .

[10]  T. Suntio,et al.  Source-Reflected Load Interactions in a Regulated Converter , 2006, IECON 2006 - 32nd Annual Conference on IEEE Industrial Electronics.

[11]  J. Freudenberg,et al.  Right half plane poles and zeros and design tradeoffs in feedback systems , 1985 .

[12]  T. Suntio,et al.  Small-Signal Models for Constant-Current Regulated Converters , 2006, IECON 2006 - 32nd Annual Conference on IEEE Industrial Electronics.

[13]  Sung-Soo Hong,et al.  Dynamics and control of DC-to-DC converters driving other converters downstream , 1999 .

[14]  M. Shoyama,et al.  Simplification of transfer function in switching converter with general load impedance , 1995, Proceedings of 1995 International Conference on Power Electronics and Drive Systems. PEDS 95.

[15]  T. Suntio,et al.  Dynamic Properties of Interconnected Power Systems - A System Theoretic Approach , 2006, 2006 1ST IEEE Conference on Industrial Electronics and Applications.

[16]  T. Suntio,et al.  Characterization of Regulated Converters to Ensure Stability and Performance in Distributed Power Supply Systems , 2005, INTELEC 05 - Twenty-Seventh International Telecommunications Conference.

[17]  B. Lehman,et al.  Accurate loop gain prediction for DC-DC converter due to the impact of source/input filter , 2005, IEEE Transactions on Power Electronics.

[18]  V. Varoli,et al.  Two-part characterization of PWM voltage regulators at low frequencies , 1988 .

[19]  R. D. Middlebrook.  Small-signal modeling of pulse-width modulated switched-mode power converters , 1988 .

[20]  T. Suntio,et al.  Source-Imposed Instability and Performance Degradation in a Regulated Converter , 2007, 2007 IEEE Power Electronics Specialists Conference.

[21]  T. Suntio,et al.  Dynamical Characterization of Peak-Current-Mode-Controlled Buck Converter With Output-Current Feedforward , 2007, IEEE Transactions on Power Electronics.

[22]  T. Suntio,et al.  The batteries as a principal component in DC UPS systems , 1990, 12th International Conference on Telecommunications Energy.

[23]  Teuvo Suntio,et al.  Use of unterminated two-port modeling technique in analysis of input filter interactions in telecom DPS systems , 2002, 24th Annual International Telecommunications Energy Conference.

[24]  Seungwon Choi,et al.  Designing control loop for DC-to-DC converters loaded with unknown AC dynamics , 2002, IEEE Trans. Ind. Electron..

[25]  Teuvo Suntio,et al.  Dynamical Characterization of Voltage-Mode Controlled Buck Converter Operating in CCM and DCM , 2006, 2006 12th International Power Electronics and Motion Control Conference.

[26]  Byungcho Choi.  Step load response of a current-mode-controlled DC-to-DC converter , 1997, IEEE Transactions on Aerospace and Electronic Systems.

[27]  B. Lehman,et al.  Performance prediction of DC-DC converters with impedances as loads , 2004, IEEE Transactions on Power Electronics.

[28]  R.D. Middlebrook,et al.  Low-Frequency Characterization of Switched dc-dc Converters , 1972, IEEE Transactions on Aerospace and Electronic Systems.

[29]  S. Luo,et al.  A review of distributed power systems part I: DC distributed power system , 2005, IEEE Aerospace and Electronic Systems Magazine.

[30]  R. D. Middlebrook,et al.  Null double injection and the extra element theorem , 1989 .

[31]  Spiro P. Karatsinides.  Line-of-sight pointing accuracy improvements through analytic boresighting , 2000, IEEE Trans. Aerosp. Electron. Syst..

[32]  Teuvo Suntio,et al.  Analysing the dynamics of regulated converters , 2006 .

[33]  Scott D. Sudhoff,et al.  Admittance space stability analysis of power electronic systems , 2000, IEEE Trans. Aerosp. Electron. Syst..

[34]  L. Brush.  Distributed power architecture demand characteristics , 2004, Nineteenth Annual IEEE Applied Power Electronics Conference and Exposition, 2004. APEC '04..