Braking resistor is known to be a very powerful tool for transient stability improvement in electric power systems. Usually, in a large power system braking resistors are placed at each generator terminal bus which requires a high installation as well as operation cost. Also, heavy computation is required for the controllers used for the switching of the resistors. From these viewpoints, this paper directs to the study of installation of reduced number of fuzzy logic controlled braking resistors at suitable locations for transient stability enhancement. Groups of coherent generators in the power system are determined. Then one braking resistor is installed in each of the coherent group and at each of the remaining generator terminal bus. Thus, the number of braking resistors is reduced and hence the installation and operation cost as well as computational burden for the controllers are minimized. The suitable location for the braking resistor in each coherent group of generators is determined according to the values of the transient stability index as calculated for a 3LG (Three-phase-to-ground) fault at the points near the generators of the coherent group without considering the braking resistors in the system. The effectiveness of the proposed method is demonstrated through EMTP simulations for the IEEJ West-10 machine model system.
[1]
A.H.M.A. Rahim,et al.
Identification of coherent generators using energy function
,
1990
.
[2]
Toshiaki Murata,et al.
An Analysis of the Fuzzy Logic Controlled Braking Resistor for Transient Stability Improvement in Multi-Machine Power System
,
2004
.
[3]
K. S. Rao,et al.
Coherency Based System Decomposition into Study and External Areas Using Weak Coupling
,
1985,
IEEE Transactions on Power Apparatus and Systems.
[4]
Robin Podmore,et al.
Identification of Coherent Generators for Dynamic Equivalents
,
1978,
IEEE Transactions on Power Apparatus and Systems.
[5]
Toshiaki Murata,et al.
A Fuzzy Logic Controlled Braking Resistor Scheme for Transient Stability Enhancement
,
2002
.