A New Efficient Adaptive Control of Torsional Vibrations Induced by Switched Nonlinear Disturbances

Abstract Torsional vibrations induced in drilling systems are detrimental to the condition of the machine and to the effectiveness of the engineering process. The cause of vibrations is a nonlinear and unknown friction between a drill string and the environment, containing jumps in its characteristics. Nonlinear behaviour of the friction coefficient results in self-excited vibration and causes undesirable stick-slip oscillations. The aim of this paper is to present a novel adaptive technique of controlling vibrating systems. The scheme is based on the linear quadratic regulator and uses direct measurements of the friction torque to synthesize its linear dynamic approximation. This approach allows generating a control law that takes into account the impact of the friction on the system dynamics and optimally steers the system to the desired trajectory. The controller’s performance is examined via numerical simulations of the stabilization of the drilling system. The proposed solution outperforms the comparative LQG regulator in terms of the minimization of the assumed cost functional and the overall stability of the control system under the nonlinear disturbance.

[1]  Donald Eugene. Farrar,et al.  Multicollinearity in Regression Analysis; the Problem Revisited , 2011 .

[2]  Jing Na,et al.  Adaptive dynamic surface control based on fuzzy disturbance observer for drive system with elastic coupling , 2016, J. Frankl. Inst..

[3]  Henk Nijmeijer,et al.  Analysis of Friction-Induced Limit Cycling in an Experimental Drill-String System , 2004 .

[4]  T. Szolc,et al.  Semi‐active reduction of vibrations in the mechanical system driven by an electric motor , 2017 .

[5]  Stefan Jakubek,et al.  Mechanical Impedance Control of Rotatory Test Beds , 2014, IEEE Transactions on Industrial Electronics.

[6]  M. J. Fear,et al.  Experience in the detection and suppression of torsional vibration from mud logging data , 1994 .

[7]  Stephen Yurkovich,et al.  Vibration control of a two-link flexible robot arm , 1991, Proceedings. 1991 IEEE International Conference on Robotics and Automation.

[8]  Marcelo A. Trindade,et al.  Performance analysis of proportional-integral feedback control for the reduction of stick-slip-induced torsional vibrations in oil well drillstrings , 2017 .

[9]  T. Szmidt,et al.  Intelligent damping layer under a plate subjected to a pair of masses moving in opposite directions , 2017 .

[10]  Anthony Tzes,et al.  An adaptive input shaping control scheme for vibration suppression in slewing flexible structures , 1993, IEEE Trans. Control. Syst. Technol..

[11]  Active control of forced vibrations in a beam via Maximum principle , 2013, 2013 5th International Conference on Modeling, Simulation and Applied Optimization (ICMSAO).

[12]  Dominik Pisarski,et al.  Online adaptive algorithm for optimal control of structures subjected to travelling loads , 2017 .

[13]  William Singhose,et al.  Command shaping for flexible systems: A review of the first 50 years , 2009 .

[14]  Ahmet S. Yigit,et al.  Fully coupled vibrations of actively controlled drillstrings , 2003 .

[15]  J. Gagné Literature Review , 2018, Journal of ultrasound in medicine : official journal of the American Institute of Ultrasound in Medicine.

[16]  M. O. Tokhi,et al.  Techniques for vibration control of a flexible robot manipulator , 2006, Robotica.

[17]  de A Bram Kraker,et al.  An approximate analysis of dry-friction-induced stick-slip vibratons by a smoothing procedure , 1999 .

[18]  Teresa Orlowska-Kowalska,et al.  Implementation of a Sliding-Mode Controller With an Integral Function and Fuzzy Gain Value for the Electrical Drive With an Elastic Joint , 2010, IEEE Transactions on Industrial Electronics.

[19]  M.J.G. van de Molengraft,et al.  H/sub /spl infin// control for suppressing stick-slip in oil well drillstrings , 1998 .

[20]  Marcin Kaminski,et al.  A Modified Fuzzy Luenberger Observer for a Two-Mass Drive System , 2015, IEEE Transactions on Industrial Informatics.

[21]  Indra Narayan Kar,et al.  Multimode Vibration Control of a Flexible Structure Using -Based Robust Control , 2000 .

[22]  Dominik Pisarski,et al.  Semi-active control of 1D continuum vibrations under a travelling load , 2010 .

[23]  Jan Dirk Jansen,et al.  Active damping of self-excited torsional vibrations in oil well drillstrings , 1995 .

[24]  Carlos Canudas-de-Wit,et al.  Nash Game Based Distributed Control Design for Balancing of Traffic Density over Freeway Networks , 2014 .

[25]  Indra Narayan Kar,et al.  Multimode vibration control of a flexible structure using H/sub /spl infin//-based robust control , 2000 .

[26]  Jeffrey R. Bailey,et al.  Managing Drilling Vibrations through BHA Design Optimization , 2009 .

[27]  Xiaohua Zhu,et al.  A Literature Review of Approaches for Stick-Slip Vibration Suppression in Oilwell Drillstring , 2014 .

[28]  Indra Narayan Kar,et al.  Bending and torsional vibration control of a flexible plate structure using H∞-based robust control law , 2000, IEEE Trans. Control. Syst. Technol..

[29]  Michael C. Constantinou,et al.  Semi-active control systems for seismic protection of structures: a state-of-the-art review , 1999 .

[30]  Hector Puebla,et al.  An Integral High-Order Sliding Mode Control Approach for Stick-Slip Suppression in Oil Drillstrings , 2009 .

[31]  Edwin Kreuzer,et al.  Controlling torsional vibrations of drill strings via decomposition of traveling waves , 2012 .

[32]  K. D. Young A polar coordinate based sliding mode design for vibration control , 1996, Proceedings. 1996 IEEE International Workshop on Variable Structure Systems. - VSS'96 -.

[33]  R. K. Agarwal,et al.  Optimal control and H/sub /spl infin// filter for control of Timoshenko beam vibrations using piezoelectric material , 1998, Proceedings of the 37th IEEE Conference on Decision and Control (Cat. No.98CH36171).

[34]  Paul E. Pastusek,et al.  Eliminating Stick-Slip by Managing Bit Depth of Cut and Minimizing Variable Torque in the Drillstring , 2012 .