Performance analysis of a parabolic trough solar collector using Al2O3/synthetic oil nanofluid

Abstract Nanofluid with unique mechanical, optical, and thermal properties, offers unique advantages over conventional fluids. In this paper, the applications of nanofluids on the parabolic trough collector (PTC) systems are investigated. A multi-field coupling simulation based on Finite Element Method (FEM) is implemented to investigate the performances of the PTC system using Al2O3/synthetic oil nanofluid as heat transfer fluid (HTF) with non-uniform heat flux distributions. The effect of Al2O3 particle concentrations and the influences of the key operating parameters on the PTC systems are also investigated. The numerical results are compared with experimental data and good agreement is obtained, proving that the proposed numerical model is feasible. It is found that the temperature gradients and the maximum temperature in the absorber are greatly reduced by using Al2O3/synthetic oil nanofluid. The temperature gradients and the deformation of the absorber decrease with the particle concentrations. The bending of the absorber decreases from 2.11 mm to 0.54 mm when the volume fraction increases from 0 to 0.05. Compared with the PTCs using synthetic oil, the collector efficiencies of the PTC systems using Al2O3/synthetic oil nanofluid are higher, moreover, the changes of temperature in the absorber with the direct normal irradiance (DNI), the inlet temperature, and the inlet velocity are remarkable reduced. This work provides a fundamental reference to the application of nanofluid in the PTC system.

[1]  P. Auerkari.  Mechanical and physical properties of engineering alumina ceramics , 1996 .

[2]  K. Goudarzi,et al.  An experimental investigation on the simultaneous effect of CuO–H2O nanofluid and receiver helical pipe on the thermal efficiency of a cylindrical solar collector , 2014 .

[3]  Zhifeng Wang,et al.  The calculation and analysis of glass-to-metal sealing stress in solar absorber tube , 2010 .

[4]  Zhifeng Wang,et al.  Experimental study of glass to metal seals for parabolic trough receivers , 2012 .

[5]  O. Manca,et al.  Effect of temperature and sonication time on nanofluid thermal conductivity measurements by nano-flash method , 2015 .

[6]  Jian Li,et al.  The analysis of residual stress in glass-to-metal seals for solar receiver tube , 2010 .

[7]  Ali Bakhsh Kasaeian.  Convection Heat Transfer Modeling of Ag Nanofluid Using Different Viscosity Theories , 2012 .

[8]  M. I. Ahmed,et al.  Heat transfer enhancement in a triangular duct using compound nanofluids and turbulators , 2015 .

[9]  Eckhard Lüpfert,et al.  Advances in Parabolic Trough Solar Power Technology , 2002 .

[10]  D. Wilcox.  Turbulence modeling for CFD , 1993 .

[11]  Y. Xuan,et al.  Aggregation structure and thermal conductivity of nanofluids , 2003 .

[12]  Zhifeng Wang,et al.  Structural reliability analysis of parabolic trough receivers , 2014 .

[13]  O. Manca,et al.  Numerical study of a confined slot impinging jet with nanofluids , 2011, Nanoscale research letters.

[14]  Davood Domiri Ganji,et al.  EXPERIMENTAL INVESTIGATION ON THE VISCOSITY OF NANOFLUIDS , 2012 .

[15]  J. Muñoz,et al.  Analysis of internal helically finned tubes for parabolic trough design by CFD tools , 2011 .

[16]  Chang Xu,et al.  Numerical study of heat transfer enhancement in the receiver tube of direct steam generation with parabolic trough by inserting metal foams , 2013 .

[17]  Hongguang Jin,et al.  Performance analysis of a parabolic trough solar collector with non-uniform solar flux conditions , 2015 .

[18]  Di Zhang,et al.  Heat transfer and flow analysis of Al2O3–water nanofluids in microchannel with dimple and protrusion , 2014 .

[19]  Hongguang Jin,et al.  A three-dimensional simulation of a parabolic trough solar collector system using molten salt as heat transfer fluid , 2014 .

[20]  R. Forristall,et al.  Heat Transfer Analysis and Modeling of a Parabolic Trough Solar Receiver Implemented in Engineering Equation Solver , 2003 .

[21]  M. Ghanbarpour,et al.  Improvement of heat transfer characteristics of cylindrical heat pipe by using SiC nanofluids , 2015 .

[22]  Rafael Almanza,et al.  Behavior of the compound wall copper–steel receiver with stratified two-phase flow regimen in transient states when solar irradiance is arriving on one side of receiver , 2004 .

[23]  S. C. Mullick,et al.  An improved technique for computing the heat loss factor of a tubular absorber , 1989 .

[24]  William W. Yu,et al.  ANOMALOUSLY INCREASED EFFECTIVE THERMAL CONDUCTIVITIES OF ETHYLENE GLYCOL-BASED NANOFLUIDS CONTAINING COPPER NANOPARTICLES , 2001 .

[25]  G. Tang,et al.  Optical property of nanofluids with particle agglomeration , 2015 .

[26]  Stephen U. S. Choi.  Enhancing thermal conductivity of fluids with nano-particles , 1995 .