Frosting model for predicting macroscopic and local frost behaviors on a cold plate

Abstract A computational fluid dynamics (CFD)-based model to predict macroscopic and local frost behaviors on a cold plate is described. The model was validated by comparing its results with a range of experimental data. The effects upon the model of various factors that affect frost formation were studied, including the inlet velocity, relative humidity, and cold plate temperature; the numerical predictions agreed very well with experimental data, with a maximum deviation of 0.3 mm in the average frost thickness. Similarly, the modeled average frost density was in good agreement with experimental data, with an error of 10% after 60 min and a maximum error of 25% during the early stages of frost formation. The model outlined herein is able to describe the localized details of frost growth, including the distribution of frost density and the absolute humidity along the y -axis, in contrast to existing approaches.

[1]  Dong-Keun Yang,et al.  Frost formation on a cold surface under turbulent flow , 2006 .

[2]  Kwan-Soo Lee,et al.  Dimensionless correlations of frost properties on a cold cylinder surface , 2008 .

[3]  Ralph L. Webb,et al.  Mass transfer on and within a frost layer , 2004 .

[4]  A. Sahin,et al.  An analytical study of frost nucleation and growth during the crystal growth period , 1995 .

[5]  Dong-Keun Yang,et al.  Dimensionless correlations of frost properties on a cold plate , 2004 .

[6]  Tae-Hee Lee,et al.  A one-dimensional model for frost formation on a cold flat surface , 1997 .

[7]  Kamal Abdel Radi Ismail,et al.  Modeling of frost formation over parallel cold plates , 1999 .

[8]  Dong-Keun Yang,et al.  Prediction of the frost formation on a cold flat surface , 2003 .

[9]  Bernard Franković,et al.  Transient two-dimensional model of frost formation on a fin-and-tube heat exchanger , 2009 .

[10]  Max Kandula,et al.  Frost Growth and Densification in Laminar Flow Over Flat Surfaces , 2011 .

[11]  Dong-Keun Yang,et al.  Modeling of frosting behavior on a cold plate , 2005 .

[12]  Chin-Hsiang Cheng,et al.  PREDICTIONS OF FROST GROWTH ON A COLD PLATE IN ATMOSPHERIC AIR , 2001 .

[13]  Robert W. Besant,et al.  A mathematical model for predicting the densification and growth of frost on a flat plate , 1993 .

[14]  Zhenyu Liu,et al.  VOF MODELING AND ANALYSIS OF FILMWISE CONDENSATION BETWEEN VERTICAL PARALLEL PLATES , 2012 .

[15]  Kamal Abdel Radi Ismail,et al.  Frost growth around a cylinder in a wet air stream , 1997 .

[16]  S. Patankar.  Numerical Heat Transfer and Fluid Flow , 2018, Lecture Notes in Mechanical Engineering.

[17]  Christian Jallut,et al.  Modelling of frost growth and densification , 1997 .

[18]  Hans Beer,et al.  Frost deposition in a parallel plate channel under laminar flow conditions , 2000 .

[19]  Rin Yun,et al.  Modeling of frost growth and frost properties with airflow over a flat plate , 2002 .

[20]  R. Barron,et al.  Heat and mass transfer to a cryosurface in free convection , 1965 .

[21]  Ralph L. Webb,et al.  A fundamental understanding of factors affecting frost nucleation , 2003 .

[22]  R. W. Besant,et al.  Modeling of frost formation in a fibrous insulation slab and on an adjacent cold plate , 1991 .

[23]  Robert W. Besant,et al.  Prediction of spatial and temporal distributions of frost growth on a flat plate under forced convection , 1993 .