Abstract The phosphide material system is an important material system for both microelectronics and optoelectronics, but integrated circuit technology on InP substrates is immature. In this work, thin-film deposition techniques and resistor processing techniques to fabricate fine-line geometry resistors for InP-based electronics are reported. Deposition parameters for d.c. reactive sputtering of tantalum in an argon-nitrogen ambient to realize tantalum nitride thin films with 50 Ωp[ sheet resistance are optimized. The dependence of electrical properties, including resistivity, Seebeck ratio and temperature coefficient of resistivity, are reported for a wide range of nitrogen flow. In common with other electronic material systems, Seebeck ratio characterization is implemented for process control monitoring of phosphide-based electronics fabrication. Material composition as a function of nitrogen flow is determined by Rutherford backscattering and elastic recoil detection. Techniques to fabricate low resistance contacts to the TaN are discussed. The processes are demonstrated with the fabrication of high-density, two-dimensional arrays of photoreceivers based on amplifiers using the tantalum nitrate resistor technology.
[1]
Burton A. Unger,et al.
The STIC Technology-A Monolithic Approach for Combining Tantalum and Silicon Technologies
,
1981
.
[2]
W. Worobey,et al.
Tantalum Thin-Film RC Circuit Technology for a Universal Active Filter
,
1976
.
[3]
Adele E. Schmitz,et al.
An InP-based HBT fab for high-speed digital, analog, mixed-signal, and optoelectronic ICs
,
1995,
GaAs IC Symposium IEEE Gallium Arsenide Integrated Circuit Symposium 17th Annual Technical Digest 1995.
[4]
M. Trudel.
Determination of the Relative Nitrogen Doping Level of Tantalum Nitride Resistor Film by Means of the Seebeck Effect
,
1972,
IEEE Transactions on Parts, Hybrids, and Packaging.