Out-of-Plane Pipe Whip for a Bent Cantilever Pipe: Comparison Between Experiment and FEM Models

The three-dimensional, dynamic, elastic-plastic response of a right-angle bent cantilever pipe, with an initially uniform, circular cross section, subjected to out-of-plane loading is examined using finite element beam and shell models in ABAQUS. The large-deflection behavior involves both bending and torsional elastoplastic deformations of the pipe, phenomena which have not been previously studied in the context of the dynamic problem of pipe whip. Initially, neglecting ovalization and local collapse (kinking), the bent pipe is modeled as a beam, using spatial beam elements in ABAQUS. This enables the basic three-dimensional kinematic behavior of the pipe to be analyzed. A similar, but potentially more accurate, analysis was then performed using shell elements. It is shown that there is no significant difference in the global dynamic plastic response. However the ovalization of the pipe cross section and formation and movement of the plastic zones (hinges) can be captured by using shell elements. This provides data which could form the basis for examining local failures in the pipe run. Previously unpublished experimental results, obtained in an earlier study by some of the present authors, are compared with the simulated results. Good agreement is observed and it is concluded that a nonlinear dynamic model using finite elements provides a rigorous approach for estimating the hazard zone (HZ) and, also, for treating the kinematics of a whipping pipe for this complex three-dimensional situation.

[1]  S. R. Reid,et al.  An elastic–plastic hardening–softening cantilever beam subjected to a force pulse at its tip: a model for pipe whip , 1998, Proceedings of the Royal Society of London. Series A: Mathematical, Physical and Engineering Sciences.

[2]  M. R. Baum,et al.  The rupture of high pressure pipework: The influence of pipeline geometry on in-plane pipewhip , 1996 .

[3]  Stephen R Reid,et al.  Pipe Whip: In-plane whipping of bent cantilever pipes , 1998 .

[4]  S. R. Reid,et al.  Large-deflection analysis of whipping pipes. I: Rigid, perfectly-plastic model , 1995 .

[5]  Stephen R Reid,et al.  Dynamic elastic-plastic behaviour of whipping pipes: experiments and theoretical model , 1996 .

[6]  Stephen R Reid,et al.  Triple plastic hinge mechanism for a bent cantilever beam subjected to an out-of-plane tip force pulse of finite duration , 1995 .

[7]  Stephen R Reid,et al.  Development of double hinge mechanisms in a bent cantilever subjected to an out-of-plane force pulse , 1990 .

[8]  J. C. Simo,et al.  On the dynamics of finite-strain rods undergoing large motions a geometrically exact approach , 1988 .

[9]  W. Johnson,et al.  The plastic hinge position in a bent cantilever struck normal to its plane by a steady jet applied at its tip , 1985 .

[10]  S. L. Rice,et al.  Impact strength of materials , 1972 .

[11]  Stephen R Reid,et al.  Non-linear dynamic analysis of cantilever whipping pipes , 1998 .

[12]  Stephen R Reid,et al.  Yield mechanisms of a bent cantilever beam subjected to a suddenly applied constant out-of-plane tip force , 1995 .

[13]  Bin Wang,et al.  Structural modelling and testing of failed high energy pipe runs: 2D and 3D pipe whip , 2011 .