Abstract An experimentally validated finite element method is used to model the sound level in rooms at low frequencies. It is demonstrated that the dimensions of rectangular rooms strongly influence the sound pressure level difference. Additional factors were investigated which are not normally considered in the frequency range where diffuse sound field conditions can be assumed. Three effects were investigated: room damping due to wall vibrations, furniture, the effect of small deviations from simple rectangular shapes. It is confirmed by field measurements that the vibrations of masonry walls and floors introduce less damping than surfaces of lightweight construction. Assigning to the FE model a damping equivalent to a surface absorption of 0.02 reproduces the effect of walls of heavyweight construction. Damping equivalent to a surface absorption of 0.15 reproduces the effects of plastered timber-frame walls, floors and ceilings. The work was briefly extended to a room pair built with heavyweight and lightweight material of construction. The modification of the shape of the room frequency response highlights well the effect of material of construction. In-situ and laboratory measurements show that furniture has little effect on steady-state room response below 100 Hz. Modelling a wall recess smaller than 0.5 m improved the agreement between prediction and measurements but the assumption of a simple rectangular room remains appropriate.
[1]
Y. Hirata.
Dependence of the curvature of sound decay curves and absorption distribution on room shapes
,
1982
.
[2]
Stephen J. Elliott,et al.
ANALYSIS OF LOW FREQUENCY ACOUSTIC RESPONSE IN A DAMPED RECTANGULAR ENCLOSURE
,
1999
.
[3]
Heinrich Kuttruff,et al.
Room acoustics
,
1973
.
[4]
B. Gibbs,et al.
Application of a finite-element model to low-frequency sound insulation in dwellings.
,
2000,
The Journal of the Acoustical Society of America.
[5]
Gerrit Vermeir,et al.
Low-frequency airborne sound transmission through single partitions in buildings
,
1997
.
[6]
S Ljunggren.
Air-Borne Sound Insulation of Single Walls at Low Frequencies: A Discussion on the Influence of Boundary and Mounting Conditions
,
2001
.
[7]
Gerrit Vermeir,et al.
Numerical simulation of airborne sound transmission at low frequencies: the influence of the room and the partition parameters
,
1997
.
[8]
John L. Davy.
The variance of decay rates at low frequencies
,
1988
.
[9]
Andrzej Pietrzyk,et al.
Sound insulation at low frequencies
,
1996
.
[10]
Sophie Maluski,et al.
Predicted and Measured Low Frequency Response of Small Rooms
,
1997
.