Thermo-Mechanical Properties of Alumina Films Created Using the Atomic Layer Deposition Technique

Interdigitated humidity sensors with atomic layer deposited (ALD) coatings of aluminum oxide demonstrated no leakage current relative to uncoated sensors stored in the ambient, indicating Al2O3 may be used to limit the effects of H2O and other chemical species in miniaturized mechanical- and electronicdevices. The long term durability of such coatings is not known, but may be predicted from the related material characteristics. The modulus and hardness of Al2O3 were therefore measured by nanoindentation using a Berkovich tip. Because the coatings are brittle and possess a significant tensile stress, the influence of film stress on the indentation measurements was quantified using a numerical analysis protocol, which also considered the effect of substrate compliance. The film stress and coefficient of thermal

[1]  G. Gottstein,et al.  Cornerstones of grain structure evolution and stability: Vacancies, boundaries, triple junctions , 2005 .

[2]  H. Y. Yu,et al.  The effect of substrate on the elastic properties of films determined by the indentation test — axisymmetric boussinesq problem , 1990 .

[3]  D. Munz,et al.  Determination of elastic modulus of thin layers using nanoindentation , 1997 .

[4]  J. Watt,et al.  Clarification of the Hashin‐Shtrikman bounds on the effective elastic moduli of polycrystals with hexagonal, trigonal, and tetragonal symmetries , 1980 .

[5]  Wilfried Vandervorst,et al.  Island growth in the atomic layer deposition of zirconium oxide and aluminum oxide on hydrogen-terminated silicon: Growth mode modeling and transmission electron microscopy , 2004 .

[6]  C. Herrmann,et al.  Multilayer and Functional Coatings on Carbon Nanotubes using Atomic Layer Deposition , 2005 .

[7]  N. Moody,et al.  Analysis of residual stress in cubic boron nitride thin films using micromachined cantilever beams , 1996 .

[8]  Victor M. Bright,et al.  Alternative dielectric films for rf MEMS capacitive switches deposited using atomic layer deposited Al2O3/ZnO alloys , 2007 .

[9]  刘磊,et al.  Nanoindentation of thin-film-substrate system: Determination of film hardness and Young's modulus , 2004 .

[10]  Y. S. Touloukian.  Thermophysical properties of matter , 1970 .

[11]  S. George,et al.  Low-Temperature Al2O3 Atomic Layer Deposition , 2004 .

[12]  K.H.J. Buschow,et al.  Encyclopedia of Materials: Science and Technology , 2004 .

[13]  Steven M. George,et al.  Al3O3 thin film growth on Si(100) using binary reaction sequence chemistry , 1997 .

[14]  Dehua Yang,et al.  Indentation fracture toughness and acoustic energy release in tetrahedral amorphous carbon diamond-like thin films , 2006 .

[15]  Christopher Roland,et al.  Thin film deposition: fundamentals and modeling , 1998 .

[16]  M. Madou.  Fundamentals of microfabrication , 1997 .

[17]  E. Arzt,et al.  Stress–temperature behavior of unpassivated thin copper films , 1999 .

[18]  T. Palstra,et al.  Encyclopedia of Materials , 2006 .

[19]  Z. Suo,et al.  Mixed mode cracking in layered materials , 1991 .

[20]  M. Ciavarella,et al.  The indentation modulus of elastically anisotropic materials for indenters of arbitrary shape , 2003 .

[21]  Brad Lee Boyce,et al.  Connections between morphological and mechanical evolution during galvanic corrosion of micromachined polycrystalline and monocrystalline silicon , 2008 .

[22]  M. Dunn,et al.  Growth of Silicon Carbide Nanoparticles Using Tetraethylorthosilicate for Microelectromechanical Systems , 2006 .

[23]  Steven M. George,et al.  The Mechanical Robustness of Atomic-Layer- and Molecular-Layer-Deposited Coatings on Polymer Substrates , 2009 .

[24]  E. Zdankiewicz,et al.  Micromachined water vapor sensors: a review of sensing technologies , 2001 .

[25]  W. Nix,et al.  Analysis of elastic and plastic deformation associated with indentation testing of thin films on substrates , 1988 .

[26]  Han-Bo-Ram Lee,et al.  Applications of atomic layer deposition to nanofabrication and emerging nanodevices , 2009 .

[27]  Warren C. Oliver,et al.  Indentation power-law creep of high-purity indium , 1999 .

[28]  Frans Spaepen,et al.  Interfaces and stresses in thin films , 2000 .

[29]  Michael G. Kovac,et al.  A New Moisture Sensor for "In-Situ" Monitoring of Sealed Packages , 1977, 15th International Reliability Physics Symposium.

[30]  J. Hutchinson,et al.  Crack patterns in thin films , 2000 .

[31]  L.P.B. Katehi,et al.  Fabrication and accelerated hermeticity testing of an on-wafer package for RF MEMS , 2004, IEEE Transactions on Microwave Theory and Techniques.

[32]  David M. Follstaedt,et al.  Finite-element modeling of nanoindentation , 1999 .

[33]  R. Jones,et al.  Mechanics of Composite Materials , 2018 .

[34]  David I. Forehand,et al.  Wafer Level Micropackaging for RF MEMS Switches , 2005 .

[35]  J. Beuth.  Cracking of thin bonded films in residual tension , 1992 .

[36]  Evaluation of the substrate effect on indentation behavior of film/substrate system , 2010 .

[37]  Michael V. Swain,et al.  Comparative Measurement of Indentation Fracture Toughness with Berkovich and Vickers Indenters , 1992 .

[38]  A. Evans,et al.  Elastic/Plastic Indentation Damage in Ceramics: The Median/Radial Crack System , 1980 .

[39]  Joost J. Vlassak,et al.  Measuring the elastic properties of anisotropic materials by means of indentation experiments , 1994 .

[40]  David C. Miller,et al.  Thermo-mechanical evolution of multilayer thin films: Part I. Mechanical behavior of Au/Cr/Si microcantilevers , 2007 .

[41]  Toshio Nakamura,et al.  Three-dimensional effects in thin film fracture mechanics , 1992 .

[42]  S. George,et al.  Molecular Layer Deposition of Alucone Polymer Films Using Trimethylaluminum and Ethylene Glycol , 2008 .

[43]  Warren C. Oliver,et al.  A new method for analyzing data from continuous depth-sensing microindentation tests , 1990 .

[44]  Helmut Baumgart,et al.  Nanoindentation Investigation of HfO2 and Al2O3 Films Grown by Atomic Layer Deposition , 2008 .

[45]  G. Pharr,et al.  Measurement of hardness and elastic modulus by instrumented indentation: Advances in understanding and refinements to methodology , 2004 .

[46]  D. Morris.  Indentation fracture of low dielectric constant materials , 2004 .

[47]  M. Laugier.  Palmqvist Crack Extension and the Center-Loaded Penny Crack Analogy , 1985 .

[48]  M. Madou.  Fundamentals of microfabrication : the science of miniaturization , 2002 .

[49]  Carl V. Thompson,et al.  Stress and grain growth in thin films , 1996 .

[50]  D. W. Hoffman,et al.  Stress-related effects in thin films , 1989 .

[51]  R. Cook,et al.  Mechanical and thermal properties of physical vapour deposited alumina films Part II Elastic, plastic, fracture, and adhesive behaviour , 2004 .

[52]  H. Fjellvåg,et al.  Simulation of growth dynamics in atomic layer deposition. Part I. Amorphous films , 2007 .

[53]  D. Stone.  ELASTIC REBOUND BETWEEN AN INDENTER AND A LAYERED SPECIMEN : PART I. MODEL , 1998 .

[54]  James Alastair McLaughlin,et al.  Intrinsic mechanical properties of ultra-thin amorphous carbon layers , 2007 .

[55]  R. King,et al.  Elastic analysis of some punch problems for a layered medium , 1987 .

[56]  William D. Nix,et al.  Effects of the substrate on the determination of thin film mechanical properties by nanoindentation , 2002 .

[57]  Sharp probes of varying acuity: Instrumented indentation and fracture behavior , 2004 .

[58]  Steven M. George,et al.  Viscous flow reactor with quartz crystal microbalance for thin film growth by atomic layer deposition , 2002 .

[59]  S. George,et al.  Nucleation period, surface roughness, and oscillations in mass gain per cycle during W atomic layer deposition on Al2O3 , 2009 .

[60]  G. Stoney.  The Tension of Metallic Films Deposited by Electrolysis , 1909 .

[61]  Mikko Ritala,et al.  Atomic layer deposition (ALD): from precursors to thin film structures , 2002 .

[62]  R. Bradt,et al.  On the Vickers Indentation Fracture Toughness Test , 2007 .

[63]  Y. S. Touloukian.  Thermal Expansion: Nonmetallic Solids , 1977 .

[64]  Steven M. George,et al.  Conformal Coating on Ultrahigh-Aspect-Ratio Nanopores of Anodic Alumina by Atomic Layer Deposition , 2003 .

[65]  N. Moody,et al.  Film thickness effects on the fracture of tantalum nitride on aluminum nitride thin film systems , 1998 .

[66]  Mikko Ritala,et al.  Atomic layer deposition chemistry: recent developments and future challenges. , 2003, Angewandte Chemie.

[67]  Y. Lee,et al.  Atomic layer deposited protective coatings for micro-electromechanical systems , 2003 .

[68]  Robert F. Cook,et al.  Indentation fracture of low-dielectric constant films: Part II. Indentation fracture mechanics model , 2008 .

[69]  Ken Gall,et al.  Characteristics of a commercially available silicon-on-insulator MEMS material , 2007 .

[70]  P. Flinn,et al.  Mechanical stress as a function of temperature in aluminum films , 1988 .

[71]  D. E. Gray,et al.  American Institute of Physics Handbook , 1957 .

[72]  M. Ohring.  The Materials Science of Thin Films , 1991 .

[73]  J. Michler,et al.  Comparison of nanoindentation results obtained with Berkovich and cube-corner indenters , 2006 .

[74]  D. Follstaedt,et al.  Mechanical properties of ion-implanted amorphous silicon , 2004 .

[75]  T. Page,et al.  Using the P-δ^2 analysis to deconvolute the nanoindentation response of hard-coated systems , 1999 .

[76]  David C. Miller,et al.  Incipient yielding behavior during indentation for gold thin films before and after annealing , 2006 .

[77]  Steven M. George,et al.  Electrical characterization of thin Al2O3 films grown by atomic layer deposition on silicon and various metal substrates , 2002 .

[78]  David F. Bahr,et al.  Adhesion and acoustic emission analysis of failures in nitride films with a metal interlayer , 1997 .

[79]  Bruce M. Clemens,et al.  Crystallite coalescence: A mechanism for intrinsic tensile stresses in thin films , 1999 .

[80]  Steven M. George,et al.  Gas diffusion barriers on polymers using Al2O3 atomic layer deposition , 2006 .

[81]  Arrelaine A. Dameron,et al.  Gas Diffusion Barriers on Polymers Using Multilayers Fabricated by Al2O3 and Rapid SiO2 Atomic Layer Deposition , 2008 .

[82]  D. W. Hoffman,et al.  Internal stresses in titanium, nickel, molybdenum, and tantalum films deposited by cylindrical magnetron sputtering , 1977 .

[83]  Joris Proost,et al.  Evolution of the growth stress, stiffness, and microstructure of alumina thin films during vapor deposition , 2002 .

[84]  Steven M. George,et al.  ZnO/Al2O3 nanolaminates fabricated by atomic layer deposition: growth and surface roughness measurements , 2002 .

[85]  Zhihui Xu,et al.  Finite element analysis of substrate effects on indentation behaviour of thin films , 2004 .

[86]  Robert F. Cook,et al.  Strength and sharp contact fracture of silicon , 2006 .

[87]  David C. Miller,et al.  Thermomechanical properties of aluminum alkoxide (alucone) films created using molecular layer deposition , 2009 .

[88]  C. Goldsmith,et al.  Wafer Level Micro-Encapsulation , 2005 .

[89]  D. S. Rickerby,et al.  The scratch adhesion test: An elastic-plastic indentation analysis , 1988 .

[90]  Victor M. Bright,et al.  The mechanical properties of atomic layer deposited alumina for use in micro- and nano-electromechanical systems , 2006 .

[91]  G. Pharr,et al.  Nanoindentation Characterisation of Coated Systems: P:S 2 - A New Approach Using the Continuous Stiffness Technique , 1998 .

[92]  K. Najafi,et al.  A hermetic glass-silicon micropackage with high-density on-chip feedthroughs for sensors and actuators , 1996 .

[93]  B. Lawn.  Fracture of Brittle Solids by Brian Lawn , 1993 .

[94]  J. Sniegowski,et al.  IC-Compatible Polysilicon Surface Micromachining , 2000 .

[95]  Joseph Alison King.  Materials handbook for hybrid microelectronics , 1988 .